User manual ROTEL RC-980BX

[. . . ] Do not place objects filled with liquids, such as vases, on the unit. Do not allow foreign objects to get into the enclosure. If the unit is exposed to moisture, or a foreign object gets into the enclosure, immediately disconnect the power cord from the wall. Take the unit to a qualified service person for inspection and necessary repairs. [. . . ] in addition , all of us at Rotel welcome your questions and comments. Save the RC-980BX shipping carton and all enclosed packing material for future use. Shipping or moving the RC-980BX in anything other than the original packing material may result in severe damage to your amplifier. Fill out and send in the owner's registration card packed with the RC-980BX. Also be sure to keep the original sales receipt. It is your best record of the date of purchase, which you will need in the event warranty service is ever required. Two UM-4/AAA size batteries (supplied) must be installed before the remote control can be used. To install the batteries, remove the cover on the back of the RR-AT94. install the batteries as shown in the illustration in the battery well. Test the control for proper operation, then replace the cover. When the batteries become weak the remote control won't operate the RA-1520 consistently. If you have any questions see your authorized Rotel dealer for advice about the best cable to use with your system. The STANDBY switch 1 is located on the left side of the front panel. to use the RC-980BX , press the STANDBY switch. The switch button will remain in its IN position and the ring around the Standby switch will light. in addition the indicators above the selected Listening input button 8 will light. When the STANDBY switch is pushed in, you can turn the RC-980BX on, or put it in Standby mode, with the POWER button E of the RR-AT94 remote control. When the RC-980BX is in Standby mode, pressing one of the RR-AT94 Input Selector buttons B turns the unit on and selects the corresponding input. If you will not be using the RC-980BX for a long period of time, press the front panel STANDBY switch to turn it Off. The button will return to its Out position and all the front panel indicator lights will turn off. Note: Be sure to set the Volume control to the minimum (full counterclockwise) position before you push in the STANDBY switch. The Tape 1 and Tape 2 inputs and outputs can be connected to any record/playback device that accepts standard line level analog input and output signals. [. . . ] Note: If you select TAPE 1 with the RECORDING control 7, the recording signal will only be available at the TAPE 2 recording outputs. To copy a tape from one tape recorder to another, connect the source recorder to the TAPE 1 inputs and outputs and set the RECORDING control to Tape 1. If you encounter problems, isolate the area of the difficulty, check the control settings, determine the cause of the fault and make the necessary changes. If you are unable to get sound from the RC-980BX, refer to the suggestions for the following conditions: The Standby Power Indicator should be lit whenever the RC-980BX is plugged into the wall power outlet. [. . . ]