User manual ROTEL RC-995

[. . . ] The unit must be connected to a power supply only of the type and voltage specified on the rear panel of the unit. Connect the unit to the power outlet only with the supplied 2-pin polarized power supply cable or an exact equivalent. Do not modify the supplied cable in any way. do not attempt to defeat grounding and/or polarization provisions. [. . . ] They are free to choose components from around the world in order to make that product the best they can. You are likely to find capacitors from the United Kingdom and Germany, semi conductors from Japan or the United States, while toroidal power transformers are manufactured in Rotel's own factory. Rotel's reputation for excellence has been earned through hundreds of good reviews and awards from the most respected reviewers in the industry, who listen to music every day. Their comments keep the company true to its goal ­ the pursuit of equipment that is musical, reliable and affordable. All of us at Rotel thank you for buying this product and hope it will bring you many hours of enjoyment. When used in a high-quality music audio system, it will provide years of musical enjoyment. With the increased use of digitally based audio media, many modern high performance audio components lack the circuitry needed to handle the signals produced by phono systems. the RC-995 is a high performance phono equalizer. The output signal from the RQ970 can be plugged into any line level input. the RC-995 uses the same sophisticated circuit designs and high quality components that have made Rotel a world-wide standard of performance. This type of design is more expensive to manufacture, but it is better for the music. Such furniture is designed to reduce or suppress vibration which can adversely affect sound quality. Ask your authorized Rotel dealer for advice about component furniture and proper installation of audio components. ] The RC-995 has conventional RCA type input connectors, the type found on nearly all audio equipment. Be sure to keep the power cords, digital signal cables and regular audio signal cables in your installation away from each other. This will minimize the chance of the regular audio signal cables picking up noise or interference from the power cords or digital cables. Using only high quality, shielded cables will also help to prevent noise or interference from degrading the sound quality of your system. If you have any questions see your authorized Rotel dealer for advice about the best cable to use with your system. Note: To prevent loud noises that neither you nor your speakers will appreciate, be sure to turn off the power to all the components in the system before you make any signal connections. The most convenient power source may be a switched power outlet on another component. Then you can leave the power switch of the RC-995 in the "on" position and it will be turned on and off with the other components. Your RC-995 is configured at the factory for the proper AC line voltage in the country where you purchased it (either 115 volts AC or 230 volts AC with a line frequency of either 50 Hz or 60 Hz). [. . . ] Connect a set of cables between the outputs of the RC-995 and one of the line level inputs of the amplifier. As always, use high quality cables and be sure to connect the Left and Right channel outputs of the RC-995 to the correct channels of the amplifier. If you encounter problems, isolate the area of the difficulty, check the control settings, determine the cause of the fault and make the necessary changes. If you are unable to get sound from the RC-995, refer to the suggestions for the following conditions: The Power Indicator should be lit whenever the RC-995 is plugged into the wall power outlet and the power switch is turned on. [. . . ]