User manual ROTEL RCC-1055

[. . . ] 1 English COV ER PH GRA L IC P HO ACE LDER Owner's Manual CD Multi-Disc Changer RCC-1055 Register your product at www. Rotel. com/register RCC-1055 CD Multi-Disc Changer 2 Important Safety Information WARNING: There are no user serviceable parts inside. Refer all servicing to qualified service personnel. WARNING: To reduce the risk of fire or electric shock, do not expose the unit to moisture or water. Do not allow foreign objects to get into the enclosure. [. . . ] The trigger input accepts any control signal (AC or DC) ranging from 3 volts to 30 volts. When a cable is connected to the 12V input and a trigger signal is present, the RCC-1055 is activated. When the trigger signal is turned off, the unit goes into standby mode. The front panel power indicator remains lit, but the display goes dark and the unit will not operate. NOTE: When using the 12V Trigger feature, leave the POWER button in the ON position. e Disc 1-5 Buttons (remote only) s Press the button that corresponds to the disc you want to select. Pressing one of the Disc 1-5 buttons when a disc is not playing simply selects the corresponding disc. If one of the Disc 1-5 buttons is pressed when a disc is playing, the RCC-1055 stops playing the current disc, selects the corresponding disc, and begins playing track 1 of the disc. 9 English Playing Discs Play Buttons Press the Play Button to play the disc indicated in the Disc Display. The disc will begin playing with Track 1, unless another track has been selected before the Play button is pressed. Unless one of the Repeat Play functions has been selected: · After the last track on discs 1 through 4 is played, the next disc is selected and play continues with track 1 of the disc. · At the end of disc 5 disc play stops. See the Repeat Play section for more information. Notes About MP3 Discs 9 and o When a disc is playing: · Press the button to skip the rest of track being played and begin playing at the beginning of the next track on the disc. Press and hold the button to advance more than one track on the disc. } Display Panel 5 The Disc Indicators A shows the positions in the Disc Tray that have discs in them. The Play Indicator is playing. } B is lit whenever a disc button to return to the begin· Press the ning of the track being played. Press and hold the button to go back more than one track on the disc. { { The Pause Indicator C is lit when disc play has been temporarily stopped with the Pause button. The Disc Selection Indicator H typically shows the number of the disc currently selected. If the Remaining Disc Playing Time display option has been selected the Disc Selection Indicator changes to a "­". The Track Indicator I shows either the track that is selected, the total number of tracks on the disc, or the number of tracks that remain on the disc. One of the Repeat Play Mode Indicators F will light if one of the repeat play options has been selected. See the Repeat Play Button section for more information. The Random Play Indicator E is lit when one of the random play options is being used. The Program Play Indicator D lights whenever the track programming function is activated. The Intro Scan Indicator G is lit when the Intro Scan feature is activated. [. . . ] If you encounter problems, isolate the area of the difficulty, check the control settings, determine the cause of the fault and make the necessary changes. If you experience problems with the RCC-1055, refer to the suggestions for the following conditions: The Disc, Track and Time indicators in the display should be lit whenever the power switch of the RCC-1055 is pushed in. If the display does not light, test the power outlet with another electrical device, such as a lamp. Be sure the power outlet being used is not controlled by a switch that has been turned off. Display Is Not Lit Hum is caused by electrical interference from other devices. [. . . ]