User manual ROTEL RCD-1070

[. . . ] WARNING: There are no user serviceable parts inside. refer all servicing to qualified service personnel. WARNING: To reduce the risk of fire or electric shock, do not expose the unit to moisture or water. Do not allow foreign objects to get into the enclosure. [. . . ] select high quality audio interconnect cables. Connect the left and right channel outputs of the RCD-1072 to the corresponding inputs on the preamplifier or other component. Before using the IR remote control, it is necessary to install two "UM-4/AAA" batteries (supplied). Remove the plastic cover on the back of the IR remote, install the batteries (observing the + and ­ polarity indications), and reinstall the cover. To use the IR remote control, aim it at the IR located in the lower left corner of sensor the RCD-1072 front panel. If you are using an outboard D/A converter or other digital processor, you will need an unprocessed digital data stream from the RCD-1072. A lighted Display on the front panel of the RCD-1072 provides useful information about the status of the unit, activation of special features, and track/time information for the disc being played. Each of these indicators is described in the detailed operating instructions that follow. The power switch is located on the front panel of your CD player. To turn the CD player on, push the switch in. The LED indicator above the switch and the Display will light up, indicating that the CD player is turned on. To turn the CD player off, push the button again and return it to the "out" position. The trigger input accepts any control signal (AC or DC) ranging from 3 volts to 30 volts. When a cable is connected to the 12V input and a trigger signal is present, the RCD-1072 is activated. When the trigger signal is turned off, the unit goes into standby mode. The front panel power indicator remains lit, but the display goes dark and the unit will not operate. Note: If you are using a switched outlet to turn on and off your CD player, you should leave the power switch in the "on" position. When AC power is applied to the unit, it will power up in fully active mode. NOTE: When using the 12V Trigger feature, leave the POWER button in the ON position. There is also a four by four matrix of track numbers (1 ­ 16) located at the right side of the display. this display indicates all of the tracks on the disc. If there are more than 16 tracks on the disc, all of the digits will light accompanied by the word OVER, regardless of which track is playing. [. . . ] As noted above, REPEAT can be used in conjunction with the RANDOM play feature. This button allows you to remove a track selection from the memorized program play list during the review procedure described above. Follow the review procedure until the desired track number is flashing. Then, instead of pressing the REVIEW button to continue, remove the displayed track by pressing the CLEAR button while the number is still flashing. [. . . ]