User manual ROTEL RCD-930AX

[. . . ] Do not place objects filled with liquids, such as vases, on the unit. Do not allow foreign objects to get into the enclosure. Iftheunitisexposedtomoisture, oraforeignobject gets into the enclosure, immediately disconnect the power cord from the wall. Take the unit to a qualified service person for inspection and necessary repairs. [. . . ] Note: If you are using a switched outlet to turn on and off your CD player, You should leave the power switch in the "on" position. When AC power is applied to the unit, it will power up in fully active mode. The RCD-930AX gives you a choice of two different kinds of output connections--an analog output signal from the built-in D/A converter for use with conventional analog audio components and a coax digital output which provides an unprocessed digital data signal for use with outboard D/A converters or digital processors. Use common sense when placing the RCD-930AX in a cabinet or when stacking other equipment. Make sure that the shelf or cabinet can support its weight. Do not stack heavy components on top of the RCD-930AX. Avoid placing the unit where it may be subject to excessive heat such as on top of a large power amplifier or near a heat register. For best performance, avoid placing the unit where it may be subject to vibration, such as near a speaker. Note: To prevent loud noises that neither you nor your speakers will appreciate, make sure the CD player is turned off when you make any signal connections. This manual shows illustrations of the front and rear panels and the RRD95 remote control. Each item in the illustrations is identified with a call out in a gray box. Remove the plastic cover on the back of the IR remote, install the batteries (observing the + and ­ polarity indications), and reinstall the cover. To use the IR remote control, aim it at the IR sensor Display area on the front panel of the RCD-930AX. This button is used to temporarily suspend play. The disc continues to spin and play will be resumed from the current position. the PAUSE indicator will light in the Display. To resume playing the disc, press the PAUSE button again or press the PLAY button. These buttons are used to select tracks on the disc. When a disc is playing, pressing the right TRACK button advances to the beginning of the next track. Pressing the left TRACK button returns to the beginning of the current track. Pressing twice quickly in succession returns to the beginning of the previous track. The new track number appears in the Display. [. . . ] To stop scanning and resume normal operation at the current track, press the SCAN button again or press the PLAY button. The TIME button allows you to step through two alternative time displays. Pressing the button once displays the time remaining in the current track, which counts down as the track continues playing. Pressing the button a second time displays the time remaining on the entire disc (or memorized program). [. . . ]