User manual ROTEL RCD-940

[. . . ] If the unit is exposed to moisture, or a foreign object gets into the enclosure, immediately disconnect the power cord from the wall. Take the unit to a qualified service person for inspection and necessary repairs. Read all the instructions before connecting or operating the RCD-940. Keep this manual so you can refer to these safety instructions. [. . . ] Most of the buttons are duplicated on the front panel and on the IR remote control. However, there are a few exceptions where the buttons are only available on one or the other. These exceptions are noted in the instructions. The power switch is located on the front panel of your CD player. To turn the CD player on, push the switch in. The LED indicator above the switch and the Display will light up, indicating that the CD player is turned on. To turn the CD player off, push the button again and return it to the "out" position. Note: If you are using a switched outlet to turn on and off your CD player, you should leave the power switch in the "on" position. When AC power is applied to the unit, it will power up in fully active mode. Your RCD-940 is configured at the factory for the proper AC voltage in the country where you purchased it (either 115 volts or 230/ 240 volts. The AC line configuration is noted on a decal on the back panel. Pressing the STOP button twice quickly in succession cancels any programmed selections (see below). This button is used to temporarily suspend play. The disc continues to spin and play will be resumed from the current position. the PAUSE indicator will light in the Display. To resume playing the disc, press the PAUSE button again or press the PLAY button. A motor-driven disc drawer, located in the center of the RCD-940, slides out to accept a compact disc and retracts to play the disc. The drawer can be closed in two ways: pushing the OPN/CLS button or pushing the PLAY button. These buttons are used to select tracks on the disc. When a disc is playing, pressing the right TRACK button advances to the beginning of the next track. Pressing the left TRACK button returns to the beginning of the current track. Pressing twice quickly in succession returns to the beginning of the previous track. [. . . ] Note that there is no need to press the PROGRAM button as each selection is memorized as it is entered. To program tracks from the front panel, select the first track number using the TRACK buttons. The track number and the program number in the display will flash for 3 seconds. While the display is flashing, press the PROGRAM button to memorize your selection. [. . . ]