User manual ROTEL RCD-945AX

[. . . ] Do not place objects filled with liquids, such as vases, on the unit. Do not allow foreign objects to get into the enclosure. If the unit is exposed to moisture, or a foreign object gets into the enclosure, immediately disconnect the power cord from the wall. Take the unit to a qualified service person for inspection and necessary repairs. [. . . ] Also be sure to keep the original sales receipt. It is your best record of the date of purchase, which you will need in the event warranty service is required. Use common sense when placing the RCD-945AX in a cabinet or when stacking other equipment. Make sure that the shelf or cabinet can support its weight. do not stack components on top of the RCD-945AX. Avoid placing the unit where it may be subject to excessive heat such as on top of a large power amplifier or near a heat register. For best performance, avoid placing the unit where it may be subject to vibration, such as near a speaker. The Power switch is located on the front panel of your CD player. To turn the CD player on, push the switch in. The ring around the switch and the Display will light up, indicating that the CD player is turned on. To turn the CD player off, push the button again and return it to the "out" position. These exceptions are noted in the instructions. [See Figure 4 for wiring illustration] If you are using an outboard D/A converter or other digital processor, you will need an unprocessed digital data stream from the RCD-945AX. When a dts-CD is played a dts data stream is provided. note: When an HDCD disc is played "HDCD" appears in the display. However the analog output is not HDCD decoded. Before using the IR remote control, it is necessary to install two "UM-4/ AAA" batteries (supplied). Remove the plastic cover on the back of the IR remote, install the batteries (observing the + and ­ polarity indications), and reinstall the cover. To use the IR remote control, aim it at the IR sensor lower left corner of the RCD-945AX front panel. The trigger input accepts any control signal (AC or DC) ranging from 3 volts to 30 volts. When a cable is connected to the 12V input and a trigger signal is present, the RCD-945AX is activated. When the trigger signal is turned off, the unit goes into standby mode. [. . . ] The RANDOM and INTRO play combination can also be used when playing CD-DA discs. Pressing the button once displays the time remaining in the current track, which counts down as the track continues playing. Pressing the button a second time displays the time remaining on the entire disc (or memorized program). When the alternative time displays are selected an "R" icon appears in the display. [. . . ]