User manual ROTEL RCD-950

[. . . ] If the unit is exposed to moisture, or a foreign object gets into the enclosure, immediately disconnect the power cord from the wall. Take the unit to a qualified service person for inspection and necessary repairs. Read all the instructions before connecting or operating the component. Keep this manual so you can refer to these safety instructions. [. . . ] Most of the buttons are duplicated on the front panel and on the IR remote control. However, there are a few exceptions where the buttons are only available on one or the other. These exceptions are noted in the instructions. Note: Should you move your CD player to another country, it may be possible to reconfigure it for use on a different line voltage. Do not attempt to perform this conversion yourself. Opening the enclosure of the RCD-950 exposes you to dangerous voltages. Consult a qualified service person or the Rotel factory service department for information. The RCD-950 should be plugged directly into a 2-pin polarized wall outlet or into the switched outlet on another component in your audio system. Be sure the power switch on the front panel of the RCD-950 is turned off (in the "out" position). Then, connect the supplied power cord to the AC power receptacle on the rear of the unit and the AC power outlet. If you are going to be away from home for an extended period of time such as a monthlong vacation, it is a sensible precaution to unplug your CD player (as well as other audio and video components) while you are away. The DIRECT ACCESS buttons may also be used to memorize tracks in PROGRAM mode (see below). Except where noted, all functions are available on the RCD-950 front panel and the IR remote control. This button is used to temporarily suspend play. The disc continues to spin and play will be resumed from the current position. the PAUSE indicator will light in the Display. To resume playing the disc, press the PAUSE button again or press the PLAY button. When the transport disc drawer is closed, pressing this button automatically opens the drawer. To close the drawer, press this button again. The drawer can also be closed by pressing the PLAY button When the drawer is open, the Display will read "OPEN". When it is closed with no disc, the display will read "NO DISC". When the drawer closes with a disc inserted, the Display will indicate the number of tracks on the disc and the total time of the disc in minutes and seconds. [. . . ] To program tracks from the front panel, select the first track number using the TRACK buttons. The track number and the program number in the display will flash for 3 seconds. While the display is flashing, press the PROGRAM button to memorize your selection. Note that once the flashing stops, you will no longer be able to memorize your selection. [. . . ]