User manual ROTEL RCD-961

[. . . ] WARNING: There are no user serviceable parts inside. refer all servicing to qualified service personnel. WARNING: To reduce the risk of fire or electric shock, do not expose the unit to moisture or water. Do not allow foreign objects to get into the enclosure. [. . . ] Then, connect the supplied power cord to the AC power receptacle on the rear of the unit and the AC power outlet. If you are going to be away from home for an extended period of time such as a monthlong vacation, it is a sensible precaution to unplug your CD player (as well as other audio and video components) while you are away. Note: To prevent loud noises that neither you nor your speakers will appreciate, make sure the CD player is turned off when you make any signal connections. Before using the IR remote control, it is necessary to install two "UM-4/AAA" batteries (supplied). Remove the plastic cover on the back of the IR remote, install the batteries (observing the + and ­ polarity indications), and reinstall the cover. To use the IR remote control, aim it at the IR located in the Display area on the sensor front panel of the RCD-961. A pair of standard RCA jacks supplies an analog output signal from the RCD-961 to the source inputs of an audio preamplifier, integrated amplifier, or receiver. select high quality audio interconnect cables. Connect the left channel output of the RCD-961 to the left channel source input on the preamplifier or other component. A lighted Display on the front panel of the RCD-961 provides useful information about the status of the unit, activation of special features, and track/time information for the disc being played. Each of these indicators is described in the detailed operating instructions that follow. If you are using an outboard D/A converter or other digital processor, you will need an unprocessed digital data stream from the RCD-961, taken before the built-in D/A converter. The power switch is located on the front panel of your CD player. To turn the CD player on, push the switch in. The LED indicator above the switch and the Display will light up, indicating that the CD player is turned on. To turn the CD player off, push the button again and return it to the "out" position. A motor-driven disc drawer, located in the center of the RCD-961, slides out to accept a compact disc and retracts to play the disc. The drawer can be closed in two ways: pushing the OPN/CLS button or pushing the PLAY button. Note: If you are using a switched outlet to turn on and off your CD player, you should leave the power switch in the "on" position. When AC power is applied to the unit, it will power up in fully active mode. There is also a four by four matrix of track numbers (1 ­ 16) located at the right side of the display. this display indicates all of the tracks on the disc. [. . . ] Press the button once and the RCD-961 will repeat just the current track, displaying the indicators REPEAT 1 in the Display. Press the button a second time and the RCD-961 will repeat the entire disc, displaying REPEAT ALL in the Display. press the button a third time to cancel the REPEAT function. As noted above, REPEAT can be used in conjunction with the RANDOM play feature. [. . . ]