User manual ROTEL RCD-990

[. . . ] If the unit is exposed to moisture, or a foreign object gets into the enclosure, immediately disconnect the power cord from the wall. Take the unit to a qualified service person for inspection and necessary repairs. Read all the instructions before connecting or operating the component. Keep this manual so you can refer to these safety instructions. [. . . ] The AC line configuration is noted on a decal on the back of your unit. Make sure that your unit is configured properly for your AC line voltage. Plug the supplied cord into the AC INPUT receptacle on the back of the unit. Once all other rear panel connections are completed, plug the power cord into an AC wall outlet or switched AC outlet on another system component. To use an outdoor antenna, connect its 300 ohm twin-conductor wire to the G and AM terminals in place of the loop antenna, only after a professional contractor has installed the antenna system in accordance with local electrical codes. 5mm mini-jack receives command codes from industry-standard infrared receivers (Xantech, etc. This feature could prove useful when the unit is installed in a cabinet and the frontpanel sensor is blocked. Consult your authorized Rotel dealer for information on these external repeaters and the proper wiring of a jack to fit the mini-jack receptacle. The POWER button is located on the front panel of the RCD-990 and is not duplicated on the remote control. The LED above the switch and the front panel display will light up. Push the button again (returning it to the OUT position), to turn the unit off. Most functions are duplicated on the front panel and on the handheld remote control shipped with your unit. When two reference numbers appear, one refers to the location of the control on the front panel, the other refers to the location of the corresponding control on the handheld remote. When only one number is shown, that control is available only on the front panel or the remote, as noted in the text. Available only on the remote control, this button temporarily reduces the brightness of the front panel DISPLAY. press the button to toggle between the normal brightness and reduced brightness. When the tuner is turned off, the DISPLAY will revert to its normal setting. Controls used for tuning the AM/FM receiver are described in the next sections of this manual. These configure the unit for differences in local markets, including FM tuning intervals, AM tuning intervals, and differences in the European RDS (Europe) or RBDS (USA) tuning provides a range of special tuning and search features based on data codes encoded with the broadcast signal. ] In the RDS PTY search mode, press a TUNING button to select the desired program type from the scrolling list in the display. To tune to a previously memorized station preset from 1 through 29, press the preset number using the NUMERIC buttons. for example , to tune to preset 3 , press the 3 button. [. . . ] The button is only functional when the AF indicator is lit. If the signal strength of the new station is weaker, the tuner will revert to the previously tuned station. The PTY search function permits you to scan available signals for RDS stations broadcasting a particular type of program content. If desired, change to a different PROGRAM TYPE using the TUNING controls to scroll through the list. [. . . ]