User manual ROTEL RD-1010

[. . . ] If the unit is exposed to moisture, or a foreign object gets into the enclosure, immediately disconnect the power cord from the wall. Take the unit to a qualified service person for inspection and necessary repairs. Read all the instructions before connecting or operating the component. Keep this manual so you can refer to these safety instructions. [. . . ] You should typically select Surround EX or discs that are labeled Dolby Digital Surround EX. 1 channel discs, Dolby Pro Logic IIx Music or Rotel XS processing will provide a more diffuse surround effect than the more highly localized Dolby EX decoding and will probably be the better 6. 1 forces the center back channel processing off for conventional 5. You can also repeatedly press the DOLBY PLII/3ST button on the front panel until the desired center back channel option is selected. Press the SUR+ button on the remote, then use the +/­ buttons to step through six optons: DD 2. 1 channel, DD Surround EX center back processing, DD with Pro Logic IIx Music center back processing, DD with Pro Logic IIx Cinema back channel processing, or DD with Rotel XS center back processing. You should typically select Surround EX or discs that are labeled Dolby Digital Surround EX. 1 channel discs, Dolby Pro Logic IIx Music or Rotel XS processing will provide a more diffuse surround effect than the more highly localized Dolby EX decoding and may be the better 7. 1 forces the center back channel processing off for conventional 5. You can also repeatedly press the DOLBY PLII/3ST button on the front panel until the desired center back channel option is selected. NOTE: When playing any Dolby Digital source, you can select one of three dynamic range control settings. 1 channel, DTS with Rotel XS center back processing, DTS with Pro Logic IIx Music center back processing, or DTS with Pro Logic IIx Cinema center back processing (available only for 7. 1 forces the center back channel processing off for conventional 5. You can also repeatedly press the DTS Neo:6 button on the front panel until the desired option is selected. Press the SUR+ button on the remote, then use the +/­ buttons to step through three optional modes: DTS 2. On the front panel, press the DTS Neo:6 button while playing a DTS source to step through the same options. Press the SUR+ button on the remote, then use the +/­ buttons to step through the optonal modes: DTS 2. 0 channel downmix, DTS 96, or DTS 96 with Rotel XS center back processing. You can also repeatedly press the DTS Neo:6 button on the front panel until the desired option is selected. This group of recordings includes any nonDolby Digital 2-channel signal from the RD-1010's digital inputs. You can play these recordings in 2-CH Stereo, Dolby 3-Stereo, 5-CH Stereo, 7-CH Stereo modes. You can also use Dolby Pro Logic II matrix surround (5. [. . . ] press the ENTER button to proceed with resetting the FACTORY DEFAULT settings. The unit will power off and then on, with the factory settings restored. To return to the MAIN menu without resetting the FACTORY DEFAULT settings, change the entry to NO and press the ENTER button. In some PAL systems, the menus may not be displayed unless there is an active video signal. [. . . ]