User manual ROTEL RDA-975

[. . . ] If the RDA-975 is placed in a bookcase or cabinet, there must be sufficient clearance around the unit and ventilation of the cabinet to allow proper cooling. Keep the RDA-975 away from radiators, heat registers, stoves, or any other appliance that produces heat. APPLICABLE FOR USA, CANADA OR WHERE APPROVED FOR THE USAGE CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT. ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU AU FOND. This symbol is to alert the user to the presence of uninsulated dangerous voltages inside the product's enclosure that may constitute a risk of electric shock. This symbol is to alert the user to important operating and maintenance (service) instructions in this manual and literature accompanying the product. The RDA-975 must be connected to a power supply only of the type and voltage specified on the rear panel of the unit. Connect the RDA-975 to the power outlet only with the supplied 2-pin polarized power supply cable or an exact equivalent. [. . . ] Pay particular attention to the power cord at the plug and where it exits the back of the unit. The power cord should be unplugged from the wall outlet if the unit is to be left unused for a long period of time. Immediately stop using the RDA-975 and have it inspected and/or serviced by a qualified service agency if: · · · · · The power supply cord or plug has been damaged. Objects have fallen into or liquid has been spilled into the unit. The unit shows signs of improper operation The unit has been dropped or damaged in any way Place the RDA-975 on a fixed, level surface strong enough to support its weight. Do not place the RDA-975 on a moveable cart that could tip over. RDA-975 Figure 1 ­ Controls and Connections DTS DECODER RDA-975 Figure 2 ­ Basic Wiring Connections DVD PLAYER DIGITAL OUT AUDIO OUTPUT VIDEO OUTPUT S-VIDEO POWER DTS SIGNAL 1 2 3 4 DIGITAL IN IN OUT WARNING:TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS: RISQUE DE CHOC ELECTRIQUE­NE PAS OUVRIR FRONT L REAR CENTER DTS DECODER MODEL NO. RDA-975 POWER CONSUMPTION: 10W OPTI COAX R SUBWOOFER RDA-975 INPUT 5. 1 CH OUTPUT 5 6 7 8 9 10 11 12 LEFT RIGHT COMPOSITE ROTEL RDA-975 DTS DECODER WARNING:TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE DIGITAL IN IN OUT CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS: RISQUE DE CHOC ELECTRIQUE­NE PAS OUVRIR FRONT L REAR CENTER DTS DECODER MODEL NO. RDA-975 POWER CONSUMPTION: 10W THIS EQUIPMENT TO RAIN OR MOISTURE. OPTI COAX R SUBWOOFER RDA-975 INPUT 5. 1 CH OUTPUT SURROUND SOUND PROCESSOR DIGITAL INPUT 5. 1 CH INPUT LDRF OPTICAL SPEAKER CONFIGURATION CENTER FRONT SMALL NONE LARGE SMALL LARGE REAR SMALL LARGE SUB ON OFF COAXIAL MONITOR TV DIGITAL SURROUND SOUND PROCESSOR MODEL NO. RSP-975 POWER CONSUMPTION: 22W COAX 1 RSP-975 SWITCHED 800W MAX COAX 2 TUNER CD TAPE AUX VIDEO 1 VIDEO 2 VIDEO 3 VIDEO 4 FRONT REAR CENTER DVD CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS: RISQUE DE CHOC ELECTRIQUE­NE PAS OUVRIR L POWER R IN OUT IN OUT IN OUT IN OUT SUB WARNING:TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. OUTPUT 1 DTS DECODER RDA-975 Figure 2 ­ Wiring Connections with Second Decoder DVD PLAYER AUDIO OUTPUT VIDEO OUTPUT S-VIDEO LEFT DIGITAL OUT RIGHT COMPOSITE ROTEL RDA-975 DTS DECODER WARNING:TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE DIGITAL IN IN OUT CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS: RISQUE DE CHOC ELECTRIQUE­NE PAS OUVRIR FRONT L REAR CENTER DTS DECODER MODEL NO. RDA-975 POWER CONSUMPTION: 10W THIS EQUIPMENT TO RAIN OR MOISTURE. OPTI COAX R SUBWOOFER RDA-975 INPUT 5. 1 CH OUTPUT DOLBY DIGITAL DECODER DIGITAL IN IN OUT L FRONT REAR CENTER OPTI COAX OUTPUT 5. 1 CH R SUBWOOFER SURROUND SOUND PROCESSOR CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN AVIS: RISQUE DE CHOC ELECTRIQUE­NE PAS OUVRIR 5. 1 CH INPUT WARNING:TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. SURROUND HI-PASS OFF ON FRONT HI-PASS OFF ON CENTER MODE PHANTOM NORMAL WIDE NORMAL LARGE/THX SWITCHED 500W MAX NONE INPUT OUTPUT TV MONITOR OUTPUT C S S-VIDEO INPUT TUNER DBS LD 1 2 3 CENTER SPEAKER 1 2 3 S-VIDEO OUTPUT VIDEO 3 RCA OUT S C VIDEO TUNER DBS VIDEO 2 VIDEO 2 SURROUND SOUND PROCESSOR MODEL NO. RSP-980 POWER CONSUMPTION: 22W CD LD 1 3 1 3 TAPE MONITOR IN OUT ZONE 2 OUT FRONT REAR CENTER L AUDIO PREOUT IN OUT RSP-980 POWER R SUBWOOFER REMOTE EXT 2 RDA-975 Contents Getting Started ______________________________________ 3 A Few Precautions Placement AC Power Input Power Switch Digital Inputs 1 AC Power and Control ________________________________ 3 12 Digital Signal Connections ____________________________ 4 5 Analog Signal Connections ___________________________ 4 25-pin Analog Output RCA Analog Outputs 25-pin Analog Input 10 11 9 Specifications ________________________________________ 5 AC Power and Control Getting Started Thank you for purchasing the Rotel RDA-975 DTS ® Decoder. Opening the enclosure of the RDA-975 exposes you to dangerous voltages. Consult a qualified service person or the Rotel factory service department for information. The RDA-975 should be plugged directly into a 2-pin polarized wall outlet or into the switched outlet on another component in your audio system. Be sure the power switch on the front panel of the RDA-975 is turned off. Then, connect the supplied power cord to the AC power receptacle on the rear of the unit and the AC power outlet. If you are going to be away from home for an extended period of time such as a month-long vacation, it is a sensible precaution to unplug your RDA-975 (as well as other audio and video components) while you are away. 3 DTS DECODER RDA-975 Power Switch 1 and Power Indicator 2 The power switch is located on the front panel of your RDA-975 digital decoder. To turn the unit on, push the switch in. The LED indicator above the switch will light, indicating that the unit is turned on. To turn the RDA-975 off, push the button again and return it to the out position. Analog Signal Connections The RDA-975 has 5. 1 channel analog output connections for sending decoded DTS information (six discrete channels: left front, right front, center, left rear, right rear, and subwoofer) to the surround processor or system controller. In addition, the RDA-975 features a 5. 1 channel analog pass-through input, which can be used to accept a decoded 5. 1 channel signal from another outboard decoder, such as Dolby Digital, to the surround processor, thus simplifying connections in an elaborate system. Digital Signal Connections The RDA-975 features two standard digital inputs (optical or coaxial) which receive a digital data stream from a DTS-compatible LaserDisc or DVD player. In addition, a pass-through digital output connector (coaxial) can be used to send the raw digital data stream to another processor, such as a Dolby Digital® decoder. Digital Inputs Digital Input Selector Switch Coaxial Digital Output DTS Indicator 5 25-pin Analog Output 10 and 7 The RDA-975's digital inputs accept a digital signal from your LaserDisc or DVD player. Two types of digital inputs are available ­ an optical input connection and a 75 ohm coaxial input connection. [. . . ] If you are using a surround processor which has a matching DB-25 input, such as all Rotel surround processors, this will provide a convenient, simplified output connection. Simply connect the output to the matching 5. 1 channel input on your surround processor using a standard female-to-male DB-25 audio connector. RCA Analog Outputs 11 A two-position switch located between the digital inputs selects the appropriate digital input connector, either optical or coax. If you connect your video disc player to the RDA-975's optical input, place this switch in the left position (labeled OPTI). If you use the coax input, slide this switch to the right position (labeled COAX). 8 The RDA-975 also provides six RCA output connectors for use with surround sound processors lacking a DB-25 input. [. . . ]