User manual ROTEL RMB-1095

[. . . ] WARNING: There are no user serviceable parts inside. refer all servicing to qualified service personnel. WARNING: To reduce the risk of fire or electric shock, do not expose the unit to moisture or water. Do not allow foreign objects to get into the enclosure. [. . . ] The RMB-1095 generates heat as part of its normal operation. The heat sinks and ventilation openings in the amplifier are designed to dissipate this heat. the ventilation slots in the top cover must be open. There should be 10 cm (4 inches) of clearance around the chassis, and reasonable airflow through the installation location, to prevent the amplifier from overheating. Likewise, remember the weight of the amplifier when you select an installation location. Make sure that the shelf or cabinet can support its considerable bulk. Because of its high power rating, the RMB-1095 can draw considerable current and may tax your home's electrical circuit. Therefore, it should be plugged directly into a 3pin polarized wall outlet. A heavy duty multi-tap power outlet strip may be used, but only if it (and the wall outlet) is rated to handle the current demanded by the RMB-1095. These modes are selectable using a toggle switch on the back panel. With the switch in the +12V TRIGGER ON position, the amplifier is turned on automatically when a 12V trigger signal is present at the 3. 5 mm Jack of TRIGGER IN on the rear panel. The amplifier will go into standby mode if the +12V signal is not present. The front panel POWER SWITCH overrides this function. it must be ON for the +12V trigger to work. Turning the switch OFF cuts power to the amplifier, regardless of whether or not a trigger signal is present. Be sure the POWER SWITCH on the front panel of the RMB-1095 is turned off (in the out position). Then, connect the supplied power cord to the POWER CONNECTOR on the back panel of the amplifier and to the AC power outlet. Your RMB-1095 is configured at the factory for the proper AC line voltage in the country where you purchased it (either 115 volts AC or 230 volts AC with a line frequency of either 50 Hz or 60 Hz). The AC line configuration is noted on a label on the back panel. THX grew from George Lucas' personal desire to make your experience of the film soundtrack, in both movie theaters and in your home theater, as faithful as possible to what the director intended. Movie sound tracks are mixed in special movie theaters called dubbing stages and are designed to be played back in movie theaters with similar equipment and conditions. [. . . ] see your authorized Rotel dealer for the appropriate cables. Connect XLR audio interconnect cables from each of the outputs from the preamplifier or signal processor to the corresponding BALANCED INPUT of the RMB-1095. The size and quality of the wire can have an audible effect on the performance of the system. Standard speaker wire will work, but can result in lower output or diminished bass response, particularly over longer distances. [. . . ]