User manual ROTEL RT-824

[. . . ] If the unit is exposed to moisture, or a foreign object gets into the enclosure, immediately disconnect the power cord from the wall. Take the unit to a qualified service person for inspection and necessary repairs. Read all the instructions before connecting or operating the component. Keep this manual so you can refer to these safety instructions. [. . . ] Press the SPEAKER B button to activate or deactivate the SPEAKER B outputs. An LED indicator located to the left of each button lights when that speaker output is activated. REC Button ZONE Button The RT-824 can record from any source to a recorder connected to the TAPE, VIDEO 1, VIDEO 2 or VIDEO 3 outputs, even while listening to a different input source. To select an input source for recording, press the REC button on the front-panel (or the equivalent ZONE button on the remote). Then, press one of the INPUT SOURCE buttons within 5 seconds to select the signal you wish to record. After making your selection (or if more than five seconds passes), the input source buttons return to their normal function, selecting a listening source. Remember, this selection is independent of the listening source. While recording, you may select a different source (for example, the builtin tuner) for listening. The record selection appears in the display to the right of the listening selection. MUTE Button The MUTE button on the remote temporarily turns off the output signal. Push this button once to turn the sound off. A mute indication will appear in the front panel display. Press the MUTE button again to restore previous volume levels. For headphone listening, deactivate both the SPEAKER A and SPEAKER B outputs. NOTE: MEMORY Button The MEMORY button is used to confirm and memorize tuner station presets. In the normal FREQUENCY TUNING mode, press a TUNING button and release to manually jump up or down to the next station frequency, regardless of whether or not a station is broadcasting on that frequency. For auto scan tuning, press and hold the TUNING button for approximately one second. An AUTO indicator appears in the front panel display and the tuner begins automatically scanning up or down through the frequencies until the next available station is detected. If this is not the desired station, repeat the automatic tuning procedure to find the next station. Weak stations will be skipped during auto tuning. In the PRESET TUNING mode, press a TUNING button and release to jump up or down to the next memorized station preset. Switch between FREQUENCY and PRESET tuning modes by pressing the SHIFT button and then the BAND/TV button on the remote control. A PRESET indicator appears in the display when PRESET TUNING is activated. NOTE: Several indicators in the front panel display assist tuning. A large display shows the tuned frequency and increases or decreases during tuning. A TUNED indicator lights when a sufficiently strong signal is received. A ST indicator lights when a stereo FM signal is received. TUNE/PRESET Button [SHIFT] TV Button The TUNE PRESET button toggles between FREQUENCY TUNING mode (the CH TUNING buttons advance to the next station frequency) and PRESET TUNING mode (the CH TUNING buttons advance to the next memorized station preset). [. . . ] When ZONE 2 is off, the POWER LED is steadily lit. Controlling Zone 2 from the Remote Location With a properly configured IR repeater system, you have full control of Zone 2 using an RR-939B remote from the Zone 2 location. You can select and operate a source, adjust the volume, and turn Zone 2 on or off. Whatever commands you send from the RR-939B will change Zone 2 and only Zone 2, just as if you were controlling a totally independent audio system in that room. These changes will have no effect on the main listening room. [. . . ]