User manual ROTEL RT-850

[. . . ] If the unit is exposed to moisture, or a foreign object gets into the enclosure, immediately disconnect the power cord from the wall. Take the unit to a qualified service person for inspection and necessary repairs. Read all the instructions before connecting or operating the component. Keep this manual so you can refer to these safety instructions. [. . . ] In the USA, implementation of the RBDS system is more recent. Fewer stations are broadcasting RBDS signals and the features may be less familiar to many users. Consult your authorized Rotel dealer for more information on RDS or RBDS broadcasting in your area. NOTE: The RDS and RBDS features are entirely dependent on the broadcaster sending encoded signals. Thus, they will only be available in markets where RDS or RBDS is implemented and where stations are broadcasting these data signals. If there are no RDS or RBDS stations, the RT-850 will function as a standard radio receiver. NOTE: RDS and RBDS services are only available on FM broadcasts. The features and buttons described below are only operational in FM mode. PTY Button The PTY search function permits you to scan available broadcasts for RDS stations broadcasting a particular type of program content. The current RDS program type will appear in the display. If desired, change to a different PROGRAM TYPE using the TUNING UP/DOWN buttons to scroll through the list. Press the PTY button a second time within 5 seconds. The tuner will attempt to find an RDS station broadcasting the selected type of program. However, standard Composite video cables provide excellent picture quality in most systems and their use for all input and output connections will greatly simplify installation and configuration of the unit. If you chose to use S-Video or Component Video connections, be aware of the following implications for the configuration of your system: On Screen Menu Display: The RT-850 ON-SCREEN MENU system is available for all inputs when using a Composite or S-Video cable from the TV MONITOR outputs to the TV set. The ON-SCREEN MENU is not available when using Component video cables. System Set-Up: System setup should be done while using a Composite video or S-Video cable connecting the RT-850 TV MONITOR outputs to the video inputs of the TV or projector. Select OSD ( ON-SCREEN MENU) from the RR-969 remote control to complete system setup. NOTE: On a PAL standard monitor, the OSD cannot be displayed until a video signal is present, irrespective of the type of video cables in use. For setup, connect the video output from your DVD player and select its input on the RT-850. The OSD will be displayed as an overlay to the video signal from the DVD player. However, both Composite and S-Video cables may be connected from the RT-850 TV MONITOR outputs to both Composite and S-Video inputs on a TV or projector. This dual connection from the RT-850 will provide limited S-Video capability in a system that is predominantly connected with Composite video cables. When both Composite and S-Video cables are connected from the same source, only S-Video will be available at the RT-850 S-Video TV MONITOR outputs. However, the Composite video REC Out will still be available. This dual connection can be used to provide video taping in a system that is predominantly connected with S-Video cables, but also includes a VCR with Composite video. Audio Source Connections Connect your audio-only source components to these RCA inputs and outputs: Video cables should have a 75 ohm impedance rating. [. . . ] To save the current settings as a USER DEFAULT Place the highlight on the USER DEFAULT SET line using the UP/DOWN buttons and use the +/­ buttons to change the setting to YES. The screen will change to a confirmation screen. Press the ENTER button to store the new USER DEFAULT settings. To return to the MAIN menu without saving any changes, change all entries on the screen to NO and press the ENTER button. If there is insufficient memory to store a USER DEFAULT configuration file, the USER DEFAULT SET option will not be available. NOTE: Resetting to factory default settings will erase all stored settings including delay settings, speaker settings, balance settings, input settings and more. [. . . ]