User manual ROTEL RX-880

[. . . ] · Do not use this equipment on hospital premises. Doing so may cause medical devices to malfunction. · Do not use this equipment in an aircraft. Doing so could cause the aircraft's equipment to malfunction. [. . . ] · Booting: Flashes white · During normal operation: Lights white · During firmware update: Flashes red · If firmware update fails: Continues flashing red after firmware update DSL or cable modem qa LINK/ACT indicators Light when a link is established at the LAN connectors qd or WAN connector qf, and flash when sending and receiving data. qs Wireless Unit/LAN connectors Connect to the Access Point or to a device such as a computer with an Ethernet connector. qf WAN connector Connects via an Ethernet cable to a communication device such as a cable or DSL modem. z Hint Use a straight-through or cross-over Ethernet cable. qg Reset switch Returns Router Unit settings to their factory defaults. See "Resetting to factory default settings" overleaf or Help for details. qh DC IN connector Connects to the AC adapter. qj MAC address The Router Unit's WAN port MAC address is printed here. qk Wall mounting holes Use these holes to hang the Router Unit to a wall. See "Hanging the units" overleaf for details. Documentation This product is supplied with the following manuals and help files: qd LAN connectors Connect via an Ethernet cable to a device such as a computer with an Ethernet connector. Quick Start Guide Describes the required preparations and settings initially necessary to connect to the Internet. RX-880 Sony Corporation 2003 Printed in Japan z Hint Use a straight-through or cross-over Ethernet cable. Troubleshooting Guide Provides solutions to common problems. Setup Page Online Help This is Help for the pages used to set up this product. Refer to it for details about setup page operations and setting items of this product. WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. To avoid electrical shock, do not open the cabinet. Address: 680 Kinderkamack Road, Oradell, NJ 07649 USA Telephone: 201-930-6972 This phone number is for FCC-related matters only. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Declaration of Conformity Trade Name: Sony Model No: PCWA-A320 Responsible Party: Sony Electronics Inc. Address: 680 Kinderkamack Road, Oradell, NJ 07649 USA Telephone: 201-930-6972 This phone number is for FCC-related matters only. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The shielded interface cable recommended in this manual must be used with the equipment to comply with the limits for a digital device pursuant to Subpart B of Part 15 of the FCC Rules and Canadian ICES-003. Le câble d'interface blindé recommandé dans ce document doit être utilisé avec les appareils pour être conforme aux limitations des appareils numériques telles que spécifiées dans la norme NMB-003 du Canada. NOTE: The power outlet should be installed near the equipment and should be easily accessible. To display the setup page online Help Display the setup page of the Router Unit or Access Point, and click or . Refer to Procedure 4 in the Quick Start Guide for details about how to display the setup page. AC adapter Names of parts and functions Wireless Unit PCWA-A320 Front Rear (With rear cover removed) ql Power switch Press to turn the device on (?) or off (a). ql w; w; 100-240 V AC jack Connect the supplied power cord. Getting help This section describes how to get help and support from Sony, as well as troubleshooting tips for your Wireless Broadband Router. About Sony's Support Options Sony provides several support options for your Wireless Broadband Router. [. . . ] 340 g) Ø0. 23 (5. 7) Ø0. 25 (6. 2) Ø0. 13 (3. 1) 0. 1 (2. 3) units: inches (mm) Recommended number of connected clients 16 or less Recommended number of connected clients 16 or less Ø0. 13 (3. 1) 0. 08 (1. 8) Protocol support TCP/IP Protocol support TCP/IP Router Unit Item Common settings Host Name Administrator Password Guest Password Time Server (NTP server) DNS Server WAN settings Connection Method Speed DHCP Client ID LAN settings IP Address Subnet Mask DHCP Server IP Address No. Other information UPN Pass Through UPnP Default setting Notes homegate ­ ­ ­ ­ Obtain an IP address automatically Auto-Detect ­ 192. 168. 11. 1 255. 255. 255. 0 16 PPTP & IPSec enabled · Do not install at an insecure location. · Do not install at a location where the Wireless Unit or Router Unit could fall as a result of shock or vibration, such as on the edge of a shelf. · Do not install at a location where the Wireless Unit, Router Unit or cables could be accidentally bumped by a person or other objects. Notes Standards IEEE 802. 11b IEEE 802. 11g Operating temperature 41°F to 95°F (5°C to 35°C) (no condensation) Storage temperature ­4°F to 140°F (­20°C to 60°C) (no condensation) Radio frequency 2. 4 GHz wireless network: 2. 4 to 2. 4835 GHz (IMS band) · Always use two screws or nails and make sure that the units are secure on the wall. [. . . ]