User manual ROWENTA DG8030 EXPERT PRESSURE IRON STEAMER

[. . . ] When using your appliance, basic safety precautions should always be followed, including the following : Read all instructions before using the Expert Pressure Iron & steamer. - Use appliance only for its intended use. - To protect against a risk of electric shock, do not immerse the appliance in water or other liquids. - The appliance should always be turned off before plugging or unplugging from outlet. [. . . ] There are many types of household water softeners and the water from many of them is perfectly acceptable for use in the expert pressure iron & steamer. However, some types of softeners, particularly those that use chemicals such as salt, can cause the appliance to leak or spit during use. If you experience this type of problem, we recommend that you try using inexpensive bottled spring water or untreated tap water. Once you have changed water it will take several uses to correct the problem. Rowenta recommends trying the steam function for the first time on an old towel or cloth that can be discarded to avoid damaging your clothes. The expert pressure iron and steamer is designed to operate using tap water. While unplugged, place the pressure iron & steamer on a stable, heat resistant surface. Fill the the tank with a maximum of 33 oz. Completely unwind the power cord and steam hose. 2) The water tank can be filled at any time during use. When refilling take care not to overfill the tank. Turning on and off Plug the expert pressure iron & steamer into a 120 volt electric outlet (Fig. 4), the iron light and steam indicator light will turn on and the steam ready light will flash. When the expert pressure iron & steamer is in use, the electric pump will make a humming noise as it pulls water into the boiler to produce steam. The expert pressure iron & steamer is ready to use when the steam ready indicator light stops flashing, (approximately 2 minutes). During ironing the temperature indicator light for the iron and the steam indicator light will turn on and off. This is normal as the temperature is being regulated. The unit is still on when these lights go out. The steam will stop when you ENG release the trigger. Recommendations: To prime the steam circuit, either before using the iron for the first time, or if you have not used the steam function for a few minutes, press the steam trigger several times in a row, holding the iron away from your clothes. Continuous green light: steam is ready for use (fig. Orange light flashes: your boiler needs rinsing (fig. [. . . ] You have not pressed the Press the "Restart" button on the control panel. Contact an Approved Service Centre to order a new rinse plug seal. USA : If troubleshooting does not assist, before consulting the retailer regarding their return/exchange policy, please telephone consumer service at 1-800-769-3682. Canada : If you are unable to trace the cause of the fault, contact an official Rowenta Customer Service Centre. [. . . ]