User manual ROWENTA DW4030D2 AUTOSTEAM

[. . . ] € Never leave the appliance unattended when it is connected to a power source or if it has not cooled down for approximately 1 hour. € Your appliance gives off steam, which may cause burns. Take extra care especially when you are ironing close to the edge or on a corner of your ironing board. Never direct the steam towards people or animals. [. . . ] When you put your iron onto its iron rest, make sure that the surface on which you put it is stable. € This product has been designed for domestic use only. Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply. Your appliance has been designed to function with untreated tap water. If your water is very hard (check with your local water authority), it is possible to mix untreated tap water with store-bought distilled or demineralised water in the following proportions: - 50% tap water, - 50% distilled or demineralised water. However, it is necessary to operate the Self-Clean function regularly in order to eliminate hard water deposits from the steam chamber. Use the self-clean function approximately every 2 weeks. If the water is very hard clean the iron weekly Heat concentrates the elements contained in water during evaporation. The types of water listed below contain organic waste or mineral elements that can cause spitting, brown staining, or premature wear of the appliance: water from clothes dryers, scented or softened water, water from refrigerators, batteries or air conditioners, pure distilled or demineralised water or rain water should not be used in your Rowenta iron. Automatic 3-position cut-out (depending on model) If, although switched on, the appliance is not moved, it will automatically switch off and the auto off light will blink after the following intervals: - After 30 sec. Wait a few seconds between each use of the button. See the section "Storing your iron". FR NL DE EN IT ES Do not add any descaling agents to the water in the water tank. Perform a self-cleaning operation and consult the chapter "What water should I use?Make sure that your laundry is rinsed sufficiently in order to remove any deposits of soap or chemical products on new clothes. Always spray starch onto the reverse side of the fabric to be ironed. Check that the steam control is set to the position. PT EL TR DA SV NO FI HR SR BG SL PL CS SK HU RU UK RO ET LV LT AR Your linen has not been rinsed sufficiently or you have ironed a new garment before washing it. The soleplate is dirty or brown and can stain the linen. Your are ironing with an inappropriate temperature selection (temperature too high). [. . . ] Your iron has been used dry for too long. You have placed your iron flat on a metallic rest-plate or ironed over a zip. The steam control is not set to the position. Steam or water come from the iron as you finish filling the tank. [. . . ]