User manual ROWENTA DW8006D1 PRO MASTER

[. . . ] € The appliance must not be used if it has fallen to the floor, shows evident of damage, leaks or fails to function correctly. To avoid any danger, have it inspected in an approved service centre. € The surfaces which are marked with this sign and the soleplate are very hot during the use of the appliances. Don’t touch these surfaces before the iron is cooled down. [. . . ] Your appliance has been designed to function with untreated tap water. If your water is very hard (check with your local water authority), it is possible to mix untreated tap water with store-bought distilled or demineralised water in the following proportions: - 50% tap water, - 50% distilled or demineralised water. However, it is necessary to operate the Self clean function regularly in order to eliminate hard water deposits from the steam chamber. Use the Self clean function approximately every 2 weeks. If the water is very hard clean the iron weekly Types of water not to use?Heat concentrates the elements contained in water during evaporation. The types of water listed below contain organic waste or mineral elements that can cause spitting, brown staining, or premature wear of the appliance: water from clothes dryers, scented or softened water, water from refrigerators, batteries or air conditioners, pure distilled or demineralised water or rain water should not be used in your Rowenta iron. also do not use boiled , filtered or bottled water. Automatic 3-position cut-out* If, although switched on, the appliance is not moved, it will automatically switch off and the auto off light will blink after the following intervals: - After 30 sec. , if the iron is left placed down on the soleplate or lying on its side. , if the iron is left standing on its heel. To switch the iron back on, move the iron gently. * depending on model 22 1103909940 DW8000-DW8100 D1_110x220 04/02/13 08:59 Page23 If there is a problem?PROBLEM Water drips from the holes in the soleplate. POSSIBLE CAUSE You are using steam while the iron is not hot enough. You are using the shot of steam button too often. You have stored the iron horizontally, without emptying it and without setting it to . Brown streaks come through the holes in the soleplate and stain the linen. You are using ironing water additives (i. You are not using the right type of water. [. . . ] You have ironed over a printed are of a garment. Your iron has been used dry for too long. Steam or water come from the iron as you finish filling the tank. You have placed your iron flat on a metallic rest-plate or ironed over a zip. [. . . ]