User manual ROWENTA DW8112D1

[. . . ] 4 or rinsing the water tank, before cleaning it, after each use. € Never leave the appliance unattended when it is connected to a power source ; if it has not cooled down for approximately 1 hour. € Your appliance gives off steam, which may cause burns, especially when you are ironing close to the edge of your ironing board. Never direct the steam towards people or animals. [. . . ] also do not use boiled , filtered or bottled water. IRONING BOARD: Due to the powerful steam output, a mesh type ironing board must be used to allow any excess steam to escape and to avoid steam venting sideways. NO FI DA IT USE 2 • Filling the water tank IMPORTANT Before filling the water tank, unplug the iron and set the steam control to dry position . 8) and return the iron to the horizontal. ES 3 • Temperature and steam adjustment PT Set the iron temperature to suit the type of material using the temperature control dial (fig. EL * depending on model Temperature control*: The temperature control light indicates that the soleplate is heating up. When the temperature control light goes off (fig. 10), the set temperature is reached and you can begin ironing. ECO STEAM Cotton linen Silk, wool Nylon IMPORTANT The iron takes longer to cool down than to heat up. We recommend that you start with fabrics to be ironed at a low temperature. For mixed fabrics set the temperature for the most delicate fabric. SV 12 • Storing NO FI MAINTENANCE AND CLEANING IMPORTANT Unplug and allow the iron to fully cool down before maintenance and cleaning. dA 13 • Anti-scale system Your iron contains an anti-scale cartridge to reduce scale deposits. This considerably prolongs the operational life of your iron. The anti-scale cartridge is an integral part of the water tank and does not need to be replaced. (prolongs the life of the iron) The Self Clean function flushes dirt and scale particles out of the steam chamber. IMPORTANT Do not use descaling agents, as these damage the lining of the steam chamber and so may impair the steam function. IT 14 • Self Clean function ES Fill the water tank with untreated tap water up to the max mark and heat the iron to the ••• temperature. unplug the iron and hold it over a sink horizontally. Hold the steam control into the Self Clean position (fig. 5a-5b) and shake the iron gently : steam will now begin to build up. After a few seconds water will emerge from the soleplate, EL rinsing dirt and scale particles out of the steam chamber. [. . . ] Use the Self Clean function and clean your iron. Clean the soleplate with a non-metallic sponge. Vacuum the holes of the soleplate from time to time. Ensure linen is rinsed thoroughly to remove any soap deposits or chemicals on new garments which may be sucked by the iron. [. . . ]