User manual ROWENTA DW9210D5

[. . . ] Never dismantle your appliance: have it inspected by an Approved Service Centre, so as to avoid any danger. Do not unplug your appliance by pulling on the cord. Always unplug your appliance: before filling or rinsing the the water tank, before cleaning it, after each use. Never leave the appliance unattended when it is connected to a power source; if it has not cooled down for approximately 1 hour. [. . . ] We recommend that you start with fabrics to be ironed at a low temperature. For mixed fabrics set the temperature for the most delicate fabric. TIP Always spray starch onto the reverse side of the fabric to be ironed. 3 • Dry ironing Set the temperature to suit the type of material without pushing the autosteam trigger and shot of steam button. 4 • Steam ironing (Autosteam & Steamforce) Your iron is equipped with the Autosteam function. The steam quantity and the temperature will adjust automatically to the selected fabric. To get continuous steam squeeze the autosteam trigger fig. Your iron is equipped with a pump called Steamforce Technology which pushes 30 % more steam into the heart of the fibres. A few seconds are necessary to produce or to stop the steam. 5 • Shot of steam Press the shot of steam button to generate a powerful jet of steam fig. IMPORTANT Leave an interval of a few seconds between each shot and wait until the flow of steam has finished before standing the iron on its heel. 3 DW9020-30-1103905566:FerClassic_BASE_110x220mm 3/02/09 17:22 Page 4 6 • Vertical shot of steam (from temperature setting (••) upwards) Hold the iron vertically and press the shot of steam button to remove creases from suits, jackets, skirts, hanging curtains etc. TIP Hold the iron 10 to 20 centimetres away from the garment to avoid burning delicate fabrics. 7 • Spray Press the spray button to dampen difficult creases fig. 8 • Anti-Drip system * It prevents water escaping from the soleplate when the temperature is too low. 9 • Auto Off function* • For your safety, the electronic system cuts off the power and the auto off indicator light flashes fig. 12 when: - The iron remains motionless for more than 8 minutes on its heel. - The iron remains flat or on its side for more than 30 seconds. - To restart the iron, just move it gently until the warning light stops flashing. 11 • Storing Allow the appliance to cool down before storing the iron standing on its heel. IMPORTANT Do not wind the cord around the hot soleplate fig. Never store your iron placed down on the soleplate. [. . . ] Do not add any descaling agents, perfumed, or scented additives to the water in the water tank. Use the Self Clean function and clean your iron if you have used the above. Fabric fibres have Clean the soleplate with a accumulated in the holes of non-metallic sponge. Your linen is not rinsed sufficiently or you have ironed a new garment before washing it. [. . . ]