User manual ROWENTA DZ9080 STEAM ADVANCE

[. . . ] DZ9080 US 1103898398 10/05/06 11:00 Page 1 Rowenta 196 Boston Avenue Medford, MA 02155 Tel. : (781)396-0600 www. rowentausa. com OFFICE LOCATION ONLY. To service product see service center information below. If your appliance needs service, ship the product to your nearest regional service center. Be sure to put your name on the outside of shipping box (no P. O. If in warranty, Rowenta will repair or replace product at their discretion. [. . . ] Check the garment label for appropriate setting. We recommend using the chart below as a guide. Ironing label Fabric Synthetic fibers e. g. viscose, polyester Silk, wool Temperature control Cotton, linen 5 DZ9080 US 1103898398 10/05/06 11:00 Page 6 YELLOW LIGHT The iron is heating up to reach the selected temperature. The temperature of the soleplate reached the selected setting. The temperature of the soleplate is too high for the selected setting. Move the iron gently to reactivate it. GREEN LIGHT NO OK RED LIGHT AUTO-OFF IMPORTANT!The iron takes longer to cool down than to heat up. We recommend that you start with fabrics to be ironed at a low temperature. For mixed fabrics set the temperature for the most delicate fabric. TIP Always spray starch onto the reverse side of the fabric to be ironed. 6 · Dry Ironing To iron without steam, slide the variable steam control lever to the position. We recommend dry ironing with an empty tank. Set the temperature for the type of material to be ironed. 7 · Steam Ironing You can steam iron from temperature setting ·· up. The steam quantity can be adjusted batween Smooth Steam (soft steam continous diffusion) up tu High Pressure Steam. We recommanded stetting to High Pressure Steam only when the iron is at temperature setting ···. Never iron or steam clothes while they are being worn. Use caution and do not direct soleplate at people, animals, etc. 6 DZ9080 US 1103898398 10/05/06 11:00 Page 7 Before ironing for the first time fill iron and allow to heat. The iron should be allowed to emit steam for at least 1 minute to remove any impurities. Press the burst of steam button a few times prior to ironing. This should also be done if iron isn't used regularly. 8 · High Pressure Steam Your iron is fitted with the new High Pressure Steam system. This technology generates higher steam pressure to enable the steam to penetrate much faster and further into the fabric. This way you get excellent results from your ironing. The steam is emitted in frequent bursts rather than continuously. [. . . ] This is normal. Not enough steam. There is insufficient water in the tank. The Anti-Drip function is active *. Iron is emitting a brown or white substance. Water may need to be changed due to hardness or organic matter. Garment has not been rinsed sufficiently. * depending on model 11 DZ9080 US 1103898398 10/05/06 11:00 Page 12 Iron is leaking. Over use of burst button. Overfilled. Allow more time between each burst. [. . . ]