User manual ROWENTA PERFECTO DUO

[. . . ] € Another is for ejecting the used grounds. It is also removable, and so can be frequently cleaned to be maintained in perfect working order. For your safety, your filter holder is equipped with a locking system to keep it in place when the pressure rises. EN 2 - SAFETY INSTRUCTIONS   Read the instructions for use carefully before using your appliance for the first time: the manufacturer shall accept no liability in the event of any improper use. [. . . ] This is due to a specific device which eliminates the pressure built up within the system. E espresso pod “ESE” for “Easy Serving Espresso” is a packaged pod (44 mm diameter) of 7g of selected coffee, ground and compacted between two paper filters, specially designed to make Italian style ristretto (small and strong) espressos. This system allows an immediate, simple, clean and comfortable use of your machine. € • • • • Before removing the water tank, remember to place the selector dial d1 in the position (Fig. Fill the tank with cold water and fit it back into the appliance (Fig. Switch on the appliance by pressing the on/off button d2. The light flashes during the preheating phase and then remains lit. Unlock the filter holder by pressing the button lightly and turning it towards the left (Fig. If required, remove the excess paper around the pod following the dotted lines (Fig. E pod with the red writing facing downwards (fold the corners of the filter paper back). Ensure that the paper is placed inside the filter; otherwise this could cause it to leak. 23 RO_COMBI_NC00025872-01_EO_rowenta 20/09/11 17:43 Page24 • • • • • • Turn the selector dial d1 to the position (steam) (Fig. In order to obtain good frothy milk, use circular movements and move from top to bottom, making sure that the steam nozzle remains straight in the middle of the container (Fig. The pump operates intermittently; this is normal. For best results, we recommend that you use pasteurised or UHT milk and that you avoid untreated or skimmed milk. During the operation, it is normal for the temperature light of the ON/OFF button to light up and then turn off. Once the froth has been formed, switch off the appliance (selector dial d1 in position). When the selector dial d1 is in position, the appliance will automatically cool down. During the cooling down phase, the LED of the ON/OFF button will flash, and hot water and/or steam will run into the drip tray. When the optimal temperature for preparing an espresso is reached, the LED remains lit. Once the steam has been stopped, clean the steam nozzle immediately as described in Paragraph 8D WARNING!€ • • • • • • The appliance Unplug the power supply before cleaning and let the appliance cool down. [. . . ] € Observe the maximum amount of water in the tank, using the water level gauge. € Lift the filter holder lid (A) and place a paper filter in the filter holder (Fig. € Fill it with ground coffee using the measuring spoon, with one spoon per cup of coffee (Fig. € Press the “on/off” button on the filter coffee maker; the light comes on, the cycle starts (Fig. [. . . ]