User manual ROWENTA RH8857

[. . . ] 20 12 SECURITY ADVICE For your safety, this appliance complies with applicable rules and regulations (Low Tension Guidelines, Electromagnetic Compatibility, Environmental Regulations. This appliance is not designed to be used by individuals (including children) with reduced physical, sensory or mental capacities, nor by individuals lacking experience or knowledge in the use of the appliance, unless they have the benefit of being under the surveillance of a responsible person, or of having received proper instructions. It is advisable to keep an eye on children in order to make sure that they do not use the appliance as a toy. This appliance may be used by children over eight (8) years old and by individuals with reduced physical, sensory or mental capacities, or lacking experience or knowledge, as long as they are properly supervised by a responsible person, as long as they have received instruction concerning the safe use of the appliance, and as long as all possible risks have been addressed. [. . . ] 2V Lithium-Ion 40 min 45 min 55 min Speed 2 « Medium» 25 min 30 min 35 min Speed 3 « Turbo » 20 min 25 min 30 min Functioning of the light charge signal (4) The light charge signals (4) will turn on when you press the Stop/Start button (d), and the signal changes during the course of use, depending on the charge level of the battery. When the battery charge level becomes too low, the “mini” light charge signal flashes. When the battery is fully discharged, the appliance turns off and the “mini” light charge signal (4) continues to flash for about 10 seconds. It will then be necessary to recharge the appliance. € The vacuum cleaner must be recharged for at least 10 minutes before it can be used again. € If the appliance does not turn on and the « mini » light charge signal continues to flash in blue, it means that the battery is discharged. You must then charge the appliance fully. Charge left 100% charged 66% charged 33% charged ① ② USING THE ELECTRO-BRUSH The electro-brush is a rotating, motorized brush that guarantees maximum cleaning effectiveness by allowing the appliance to suck up dirt and clean in depth. The bristles, located all along the brush, remove threads, hair and fur that might be caught on the surface of rugs and carpets. Please note: If the vacuum head adheres too closely to the surface you are cleaning, change the speed to « Minimum ». 16 * May vary according to model ATTENTION: Do not vacuum large fragments of broken objects, as they could block and damage the brush. Do not use the electro-brush on long hair carpets, on animal fur, or on fringes. REMOVING AND CLEANING THE ELECTRO-BRUSH ATTENTION: Always turn off the appliance and unplug it before storing or cleaning. Using the tool provided with the appliance (15), press in the two latches located on each side of the lower side of the Delta head (fig. Lift the trap located on top of the electro-brush (fig. Remove the electro-brush and its lateral bearing in order to clean them (fig. Carefully remove any threads, hair, fur, etc. Once clean, replace the electro-brush and its lateral bearing (fig. 11), then replace the trap over it (fig. Finally, using the tool provided with the appliance, close both latches (fig. FOR YOUR SAFETY • Do not touch any rotating parts before you turn off and unplug the vacuum cleaner. € Do not use the appliance on wet surfaces. [. . . ] If it is, it means that the appliance is not charged, so proceed to charge it. If the 3 blue light charge signals start to flicker simultaneously and very rapidly when you plug the charger to the vacuum cleaner, it means that you are not using the appropriate charger or that the one you are using is faulty. If your appliance does not vacuum • The electro-brush is dirty: clean it. € The separator is clogged up: remove the dust tray and clean the separator. [. . . ]