User manual ROWENTA RO8366EA SILENCE FORCE MULTI CYCLONIC ANIMAL CARE PRO

[. . . ] Vacuum cleaner is the same as your supply voltage. €¢ Do not use the appliance if: the Unplug the appliance by removing the power plug, cord is damaged. In order to avoid -without pulling on the power cord: immediately after use, all danger, the cord winding - before each time you change the accessories, system and the cord itself of your - before cleaning, maintaining or changing the filter. Important: the must be protected by a fuse vacuum cleaner must necessarily least 16 Amps AC outletthe circuit breaker trips whenof at rating. [. . . ] €¢ Fit the telescopic metal tube to the end of the grip until you hear a 'click' (fig. 3) (to remove, press the tube lock button and pull). Fit the ERGO COMFORT SILENCE nozzle (19) to the end of the telescopic metal tube until you hear a 'click' (fig. 4) (to remove, press the button on the nozzle and pull). Adjust the telescopic metal tube to the required length using the telescopic system (fig. ERGONOMIC RECOMMENDATIONS Ergonomic, the ERGO COMFORT SILENCE range has been designed to facilitate and improve user comfort when vacuuming. to prevent bending over and to ensure upright posture , make sure you: 1. Adjust the length of the ERGO COMFORT SILENCE telescopic metal tube to your body size (fig. Place your other hand in front of the ERGO COMFORT grip handle (fig. Fit the required accessory on to the end of the telescopic metal tube or the grip: - For rugs and carpets : use the 2-position nozzle (19) on carpet position (brush retracted) or turbo brush* (fibres and animal hair). - For hard flat floors and hard flat floors with crevices (such as tiled floors): use the 2-position nozzle (19) on hard floor position (brush extended) or, for better results, use the hard flat floor nozzle* (22a*) without the removable brush. - For fragile hard flat floors, such as parquet, it is recommended to use the hard flat floor nozzle (19*) or (22b*). IMPORTANT: The nozzle for hard flat floor with crevices 22a* is used to measure performance associated to the energy label. This nozzle allows you to optimize the dust-collection performance of your appliance on hard flat floors with crevices. - For corners and hard-to-reach areas: use the telescopic crevice nozzle*. - For upholstery and delicate surfaces: use the brush with the grip (EASY BRUSH) or the upholstery nozzle*. IMPORTANT: Always switch off and unplug your vacuum cleaner before changing the accessories. 2 • Plugging in the power cord and switching on the appliance Unwind the power cord completely, plug in your vacuum cleaner and press the ON/OFF pedal (fig. ATTENTION: do not operate your vacuum cleaner without the filtration system fitted (foam, microfilter and filter). Adjust the suction power using the manual power control* on the grip (fig. 9): • Position (MIN) for vacuuming delicate fabrics (net curtains, textiles) • Position (Medium) for everyday vacuuming for all types of floors, which are only slightly dirty • Position (MAX) for vacuuming hard floors and very dirty rugs and carpets. 3 • Storing and transporting the appliance After use, switch off your vacuum cleaner by pressing the ON/OFF pedal and unplug it (fig. [. . . ] If the cone separator (14a) fills up • Dust accumulates in the separation compartment (14c): check that the pipe between the separator (14c) and the dust compartment (11) is not blocked. Check that nothing is obstructing the dust compartment inlets. €¢ The dust compartment inlets are obstructed: remove the dust compartment and empty it. If the suction attachment is difficult to move • Open the manual power switch* on the grip. [. . . ]