User manual ROWENTA SEW N PRESS

[. . . ] Incorrect reassembly can cause a risk of electric shock when the iron is used. Close supervision is necessary for any appliance being used by or near children. Do not leave iron unattended while connected or on an ironing board. Burns can occur from touching hot metal parts, hot water or steam. [. . . ] Do not spray silk, etc. BURST OF STEAM To remove stubborn wrinkles or press in a sharp crease, use the burst of steam button. Press the button firmly, a strong burst of steam penetrates deep into the fabric. Leave an interval of at least four seconds between pressing the burst of steam button. With water in the tank, the burst of steam button can be used as soon as the steam ironing temperature has been reached (qqq) 6 Vertical steam The iron can also be used vertically. This is especially useful for getting creases out of hanging clothes, curtains, tapestries, etc. To steam vertically press the burst of steam button while holding iron in the upright position. Warning: Never iron clothes while they are being worn. DRY IRONING Sliding the variable steam control fully to the left, dry ironing can be performed either with or preferably without water in the tank. min max AFTER IRONING Turn temperature control dial completely to minimum. Slide the variable steam control completely to minimum empty any water left in the tank. For easy storage the cord can be wound loosely around the iron once the iron has cooled off completely. Always store the iron on its heel to protect the soleplate. WATER TO USE IN ROWENTA IRONS Tap water: Rowenta irons are designed to be used with REGULAR TAP WATER (up to 12 grains of hardness). If your water is harder than this, Rowenta recommends mixing half tap water with half distilled water which reduces the hardness; or use just inexpensive bottled spring water. Never use 100% distilled water since this can cause the iron to spit and leak. Softened water: There are many types of household water softeners and the water from many of them is perfectly acceptable for use in an iron. However, some types of softeners, particularly those that use chemicals such as salt, can cause the iron to leak or spit during use. If you experience this type of problem we recommend that you try using inexpensive bottled spring water or untreated tap water. Once you have changed water it will take several uses to correct the problem. Rowenta recommends trying the steam function for the first time on an old towel or cloth to avoid damaging your clothes. 7 Iron and other impurities: If your water supply contains large amounts of iron or organic matter, these minerals can collect inside the iron and eventually appear as brown stains. If you experience these problems Rowenta recommends using inexpensive bottled spring water. CLEANING AND MAINTENANCE When cold and unplugged, the iron can be cleaned with a damp cloth and wiped dry. [. . . ] If you experience leaking or spitting, change to untreated tap water or a 50/50 tap/distilled water mix or inexpensive bottled spring water. Allow iron to heat up (indicator light goes out) before using steam control. Turn thermostat to a higher setting. Softened water. Is iron hot enough? Overuse of the burst of steam. This is normal. Indicator light goes on and off. The light goes on and off showing the thermostat is switching the heat on and off to maintain the correct temperature. [. . . ]