User manual ROYAL SOVEREIGN NB-1900N

[. . . ] Do not operate machine for any other purpose other than its intended use. Do not operate machine if electrical plug or power cord is damaged. Turn off the power when unattended or not in use. Unplug machine before moving it or when it is not in use for an extended period of time. [. . . ] Leave a minimum border of about 3mm(1/8"), to provide a proper edge seal. Insert pouch squarely into opening slot. Finished lamination will exit through rear of machine. Emerging laminated document is hot to the touch. (Always allow lamination to cool down on a flat surface for about a minute before handling, to prevent permanent bending. If document is not laminated well, re-insert it and run it through a second time. ) 8. When continuously laminating, run the laminator at a lower setting because the internal machine temperature may be higher than the required temperatur, causing the document to bend or ripple. When finished laminating, turn off the machine. ***USEFUL INFORMATION*** * Sometimes, when continuously laminating, LED may begin blinking. If this happens, finish laminating the current document, then wait until the LED stops blinking, before inserting the next lamination. * Do not laminate empty or thin pouch on a thick film setting. * Do not unplug laminator while laminating. This could be fatal for the rollers due to the high internal temperature. EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500 9 2. Press the power button to turn laminator on. Press COLD It is ready when green LED blinking stops and buzzer rings. Insert document into Royal Sovereign cold laminating pouch as follows. **HOW TO ATTACH DOCUMENT ON COLD POUCH FILM** 1) Prepare cold pouch film. 2) Remove protective paper inside cold pouch. Back (Be careful not to allow the pouch to close and seal itself closed. If the pouch closes on itself and seals, you will not be able to the document to be laminated inside. ) Front 3) Place document squarely into the pouch, where the protecting paper was. Cold film's minimum border of about 3mm(1/8") is necessary to provide a proper edge seal. 4) Beware of dust while inserting document. Back 5) Feed pouch squarely into opening slot. Finished laminated pouch will exit through rear of machine. When you are finished laminating, press the power button to turn off. ***USEFUL INFORMATION*** If it has recently been used for hot lamination, allow the rollers to be cooled down about 20~30 minutes. EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500 10 3. [. . . ] Place the machine on a sturdy, flat work surface to prevent damage. Make certain that the machine is connected to an adequate power source. This warranty does not cover damage or injury resulting from improper use or failure to follow the instruction manual provided. In no event will manufacturer, importer, warranty service center, its agents or assigns, be liable for losses, either direct or indirect, including but not limited to special, incidental, consequential, or punitive damages whatsoever incurred arising out of any breach of warranty by manufacturer, importer, warranty service center, their heirs or assigns or successors in interest. [. . . ]