User manual ROYAL KLIMA 12

[. . . ] 004771021 - Claudia - Ivana - Antonella - Klima 12 GB Royal's series of heating appliances are made and tested following the safety rules and regulations as laid down in the relative European directives. This manual is for owners, installers, operators and maintenance engineers of the series of stoves. If you have any doubts about the contents or need some clarifications, do not hesitate to contact the manufacturer or an authorised technical assistance centre, giving the number of the paragraph in question. The printing, translation and reproduction, even partial, of this manual are bound by Royal's authorisation. [. . . ] Anchor the pipes to the wall with the relative collars.  The smoke discharge fitting MUST NOT BE connected: to a flue used by other heat generators (boilers, stoves, fireplaces, etc. If the smoke discharge path is longer than 5 metres and the draught is not very good (many bends, inadequate discharge terminal, etc. In such cases the operating parameters will have to be altered (smoke expulsion and pellet loading) to adapt the stove to the flue’s characteristics. 1 Discharge through the roof with a flue The flue for discharging smoke must be made in compliance with the EN 10683 - EN 1856-1-2 - EN 1857 - EN 1443 - EN 13384-1-3 - EN 12391-1 standards both as regards the dimensions and the materials used to make it. dETERIORATING flues made with unsuitable materials (such as asbestos cement , galvanised steel , etc. , with a rough or porous internal surface) are illegal and can jeopardise the correct operation of the stove. Smoke may be discharged through a traditional flue (fig. 4) provided the following rules are observed: make certain the flue is in a good state of repair. If the flue is old we suggest inserting a suitably lagged steel pipe (rock wool, vermiculite). Smoke can be discharged directly through the flue only if it has a maximum cross section of 15 × 15 cm or 15 cm in diameter and is fitted with an inspection hatch. If the flue section is bigger it must be ducted using an adequately insulated steel pipe (the diameter depends on the length of the path) (Fig. Make sure the connection to the brickwork flue is perfectly sealed. Avoid contact with flammable materials (timber beams) which must, in any case, be insulated with a fire-retardant material. 004771021 - Claudia - Ivana - Antonella - Klima 12 GB 6 INSTALLATION The installation must be carried out by qualified personnel in compliance with the EN 10683-05. 1 LEVELLING THE STOVE The stove must be levelled by turning the adjustment feet (Fig. 1 Electrical connection Simply connect the stove to the electricity mains with the plug supplied. The electrical connection (plug) must be easy to access also after the stove has been installed. If the power lead is damaged it must be replaced by the technical assistance service or a qualified electrician to prevent all risks. 1 Earthing  The system must be earthed and fitted with a circuit breaker as provided for by current laws (Fig. The flue must have its own earth connection. 2 Starting To start, press the switch down, "I", (On) (Fig. [. . . ] Failure to clean or clean thoroughly will probably lead to stove operating problems, such as: bad combustion; blackening of the glass; clogging of the hearth with an accumulation of ash and pellets; deposit of ash and encrustation on the exchanger leading to poor heat efficiency. 5 Adjusting the handle The handle on the door is already factory-set for optimum closing. After a few weeks of use and normal settling of the seals, the handle might need adjusting to ensure perfect closing of the door. In such an event proceed as follows: loosen the securing screw (A) (with a 2mm Allen wrench). [. . . ]