User manual RUSSELL HOBBS 14337

[. . . ] This is a safety feature ­ do not attempt to overcome it. 8 Unplug before dismantling or cleaning. 9 Don't leave the processor unattended while plugged in. 10 This processor is designed to process small quantities of food. [. . . ] 26 Before using the processor to crush ice, make sure it's clean, and rinse the bowl out thoroughly. The slightest trace of detergent may affect the taste of the crushed ice, and will flatten any drink to which it is added. 27 Ice "cubes" come in many shapes and sizes. You'll have to experiment with the ice from your ice cube tray. 28 Start with half to threequarters of a cup of ice, or 4 to 6 cubes, and add 15ml (1 tablespoon) of fresh cold water. 29 Assemble the processor, then press the switch 4 3 or 4 times, with short pauses between. Too much processing will reduce the ice to liquid, too little will merely chip the edges/corners off the ice. 31 Don't try to crush ice without adding water to the bowl. 32 Don't be tempted simply to increase the amount of ice and blend for longer. Too much ice will never give you satisfactory results. the creamer 33 Although this isn't a blade, it can be fitted in exactly the same way as the blade units. 34 Use it to whip cream ­ use it in bursts, and keep an eye on the results. 35 Take care not to overdo it ­ 5 to 10 seconds in total should be sufficient 36 You'll probably have to remove the lid to check progress ­ lift it at an angle, so any cream on the lid drips back into the bowl and not on the work surface. care and maintenance 1 Unplug the processor before dismantling or cleaning. 3 Lift the processing lid off the bowl ­ hold it at an angle, to let anything on it drip back into the bowl. 4 Hold the plastic part of the blade unit, turn it to free it from the spindle flanges, and lift it straight up and out of the bowl. Take care ­ the blades are very sharp 5 Take care when you're handling and cleaning the blade unit ­ if you can't see what you're doing, don't do it. 6 Wipe the outer surfaces of the motor unit with a damp cloth. If necessary, use a little washing-up liquid. 7 Wash the bowl, lids, blade units and creamer in warm soapy water. 5 8 Rinse to remove all traces of soap and air dry. 9 Clean the inside of the blade units with a toothpick, or the end of a small bottle brush. 10 Don't put the motor unit in water or any other liquid. 12 Don't use harsh or abrasive cleaning agents or solvents. [. . . ] It's on the rating plate (usually underneath the product). The product isn't user-serviceable. If it's not working, read the instructions, check the plug fuse and main fuse/circuit breaker. If it's still not working, consult your retailer. [. . . ]