User manual RUSSOUND BGD1

[. . . ] Locate the product so as not to interfere with its proper ventilation. Don't use the product on a bed, sofa, rug, or similar surface that may block the ventilation openings, or in a bookcase or cabinet that may impede the flow of air through the ventilation openings. Use the right power. Don't connect the product directly to electrical line voltage. Use only the power adapter provided with the product, described in the operating instructions, or as marked on the product. [. . . ] Crimp an RJ-45 connector on the source end of the CAT-5 cable, following the T568A standard as shown. Plug the connector into the RNET A/V jack on the Dock. (If using a wall plate, punch down the CAT-5 per the T568A standard and use a straight-through patch cable between the Dock and the wall plate. ) 4. Crimp an RJ-45 connector on the system end of the CAT-5 cable, following the T568A standard as shown. Plug the connector into the RNET A/V jack on the Decoder. (If using a wall plate, punch down the CAT-5 per the T568A standard and use a straight-through patch cable between the Decoder and the wall plate. ) RJ-45 Using T568A Wiring Standard Setup for RNET Control 1. With the audio system turned off, use an RJ-45 patch cable to connect from either RNET Link jack on the Decoder to an RNET Link jack on the system or an RNET source component. Use an RCA patch cable to connect from the Decoder's audio outputs to a source audio input on the RNET system controller. Note: The Decoder's video output does not function in RNET mode. 2. Set the source/ function selector switch on the Dock to the number of the source input the Decoder is connected to on the RNET system. Plug the power adapters into AC power receptacles and connect their output leads to the device power jacks. Put the iPod in the Dock with the appropriate iPod adapter. Power up the audio system and select the source input you're using for the iPod. As long as the iPod is playing, you should hear it through the audio system. Follow the RNET system's programming instructions to configure the iPod source as a peripheral device. If the system includes UNO-TS2 touchscreens, also use the Screen Setup feature in the UNO-TS2 Options menu to configure the iPod as an "iPod (iBridge)" source type to assign the correct screen template. 5 Installation Setup for IR Control 1. With the audio system turned off, use an RCA patch cable to connect from the Decoder's outputs to a source input on the audio system. Use an IR link cable or mono patch cable with 1/8-inch (3. 5 mm) TS connectors to connect from the system's IR output to the Decoder's IR input. Set the source/function selector switch on the Dock to IR for infrared control of the iPod. Plug the power adapters into AC power receptacles and connect their output leads to the device power jacks. Put the iPod in the Dock with the appropriate iPod adapter. Power up the audio system and select the source input you're using for the iPod. As long as the iPod is playing, you should hear it through the audio system. [. . . ] For this warranty to apply, the unit must be installed and used according to its written instructions. If service is necessary, it must be performed by Russound. The unit must be returned to Russound at the owner's expense and with prior written permission. Accidental damage and shipping damage are not considered defects, nor is damage resulting from abuse or from servicing by an agency or person not specifically authorized in writing by Russound. [. . . ]