User manual RUSSOUND COMPOINT SYSTEM

[. . . ] ComPointTM The music lover's intercom solution Instruction Manual SAFETY PRECAUTIONS 1. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding plug. [. . . ] If the ComPoint system is sharing speakers with an audio system, loop the speaker cables through the keypad locations. If dedicated speakers are being used, run the speaker cables to the keypads. 19 INSTALLER SECTION Installation Speaker connections Each keypad has an 8-pole screw-terminal connector for accessing the internal speaker relay. This connector is typically used for connecting the zone speakers in a multiroom audio system. In a zone where the ComPoint system does not share speakers with an audio system, connect a dedicated speaker or pair of speakers to the output terminals. Note: Both speaker output channels must be connected, since they are wired in series. If you are using a single dedicated 8-ohm speaker such as the ISSP ComPoint Speaker, connect the speaker to one channel and a shorting jumper to the other channel. If you are using a single 4-ohm speaker, connect it to one channel and a 4-ohm, 2-watt power resistor to the other channel. Be sure to observe polarity when connecting the speaker wires. The standard color code for 4-conductor speaker cable is as follows: Wire Color White Green Black Red Polarity Left + Left ­ Right ­ Right + Hub modular connections The hub has 8-pole modular jacks for keypad and door station connections. The keypads connect to ports 1 through 6, and the door stations connect to DOOR1 and DOOR2. These connections must be made according to the T568A standard as shown below. 8-pole modular T568A connection The hub also uses modular jacks for the link ports. You may use any 8-pole straight-through RJ-45 patch cable to link hubs together. Doorbell connections ComPoint can operate a separate doorbell system as well as provide doorbell chime tones in the zones. To use a separate doorbell, connect each door station to the doorbell as shown below or in the doorbell system instructions. y OUT TO SPEAKERS IN FROM AMPLIFIER L+ L- R- R+ L+ L- R- R+ Doorbell Transformer Doorbell 2-conductor cables to speakers 4-conductor cable from amplifier Multiroom speaker connection to keypad Doorbell connection to rear of ISK3 Door Station 20 INSTALLER SECTION Programming Door strike release connections The door strike release module has 110 punchdown connectors for the hub and door station cables. It also has screw terminals for its relay contacts that accept up to 14 AWG stranded wire. The figure below shows the connections. To ISK3 Door Station System programming Overview All system programming resides in the ISH1 hub. For a six-zone system with ISK1 Basic Keypads, programming consists only of setting the doorbell chimes. For a system with ISK2 Advanced Keypads, programming includes assigning zone and door station labels. For a system with more than six zones, programming includes setting hub ID numbers. DIP switches on ISH1 hub To door strike release unit From ISH1 Hub Door Strike Release Module connections The ISH1 hub has DIP switches for setting the doorbell chime and hub ID number assignments. The hub's firmware includes zone and door station labels for display on the ISK2 Advanced Keypads. These labels are assigned by using a connected ISK2 keypad. With multiple hubs, the label settings are initially stored in the hub to which the keypad is connected. [. . . ] DND mode can be used in conjunction with Listen mode as long as Listen mode is selected first. If DND is selected first, pressing any key to enable Listen mode will exit DND mode. When a zone attempts an intercom session with a zone that is in DND mode, the DND key on the sending keypad blinks red for 7 seconds after the Talk key is pressed. Also, on the ISK1 Basic Keypad, the zone key for the zone in DND mode blinks red. [. . . ]