User manual RUSSOUND CONTRACTOR

[. . . ] built for sound - priced for value INTRODUCTION Thank you for selecting the Russound Contractor Series In-wall/In-ceiling Speakers. Like all Russound speakers, they combine acoustic technology with durability and will provide years of musical enjoyment. An added feature of models SP-C503, SP-C522 and SP-C622 is the dual voice coil design. This is unique in that both left and right signals can function in one speaker, which is ideal for smaller installations or where there is no preferred listening position. [. . . ] Then use a keyhole/drywall saw or motorized spiral-cut tool to make the opening. - If you're dealing with lath and plaster or thick paneling, you need to use a different technique. Drill 1-inch holes at the corners of the pencil outline. Then use a fine-toothed keyhole saw or even a hacksaw blade with VERY slow strokes to saw through and remove the inner surface. Cut off excess wire, leaving enough to comfortably reach from the hole in the wall to your stereo system. If there's a possibility that you're going to move the amplifier to another part of the room, consider leaving some excess wire coiled up. If you've used sufficiently thick wire, this extra length will not affect speaker performance and could make re-routing easier if the room is rearranged later. Pull the conductors on both speaker wires apart so they're separated for the last two inches. Using wire strippers, diagonal pliers or a knife, remove 1/2 inch of insulation from each conductor. Twist the tiny strands in each conductor into tight spirals. Attach the speaker wires to the red and black speaker terminals on the amplifier or receiver. * Connect the POSITIVE (+) conductor to the RED terminal and the NEGATIVE (-) conductor to the BLACK speaker terminal of the receiver/amplifier. Make sure that no stray strands of wire have gotten detached and are touching the other main wire. Repeat Steps 1 through 5 for the other speaker. LISTENING TEST It's a good idea to test everything at this point. Make sure that the VOLUME control is turned down and that the BALANCE control is set to center. Activate a musical source such as FM or CD player. You should hear music coming out of your new Russound Speakers!(If you don't, refer to the troubleshooting guide below. ) 4. Now rotate the stereo's BALANCE control all the way to the LEFT. Sound should only come out of your left speaker. If it comes out of the RIGHT speaker, skip to Step 6. Rotate the BALANCE control all the way to the RIGHT. [. . . ] Russound makes a complete line of products from Impedance-Matching Volume Controls to Impedance-Matching Speaker Selectors. Ask you Russound dealer for details or contact Russound Sales at 603-659-5170. 6 Figure 9 New construction rough-in bracket placement for ceiling speaker SPEAKER SPECIFICATIONS Model: SP-C503 Description: Round Dual Voice Coil In-wall/In-ceiling loudspeaker Woofer: 5. 25" (13. 3 cm) poly-mica with enhanced high-frequency Cut-Out: 6. 5" (16. 5 cm) Mounting Depth: 3. 25" (9. 5 cm) Recommended Power: 5 - 50 watts Efficiency: 88 dB (1W @ 1M w/1kHz) Frequency Response: 65Hz - 16kHz +/- 3 dB Nominal Impedance: 8/8 ohms per channel Model: Description: Woofer: Tweeter: Cut-Out: Mounting Depth: Recommended Power: Efficiency: Frequency Response: Nominal Impedance: Model: Description: Woofer: Tweeter: Cut-Out: Mounting Depth: Recommended Power: Efficiency: Frequency Response: Nominal Impedance: SP-C522 Round Single-Point Stereo In-wall/In-ceiling loudspeaker 5. 25" (13. 3 cm) poly-mica Dual 1/2" (1. 3 cm) Neodymium Mylar 6. 5" (16. 5 cm) 3. 25" (9. 5 cm) 5 - 50 watts 89 dB (1W @ 1M w/1kHz) 65Hz - 20kHz +/- 3 dB 8/8 ohms per channel SP-C622 Round Single-Point Stereo In-wall/In-ceiling loudspeaker 6. 5" (16. 5 cm) poly-mica Dual 3/4" (1. 9 cm) Neodymium Mylar 7. 375"(18. 7 cm) 3. 75" (9. 5 cm) 5 - 60 watts 90 dB (1W @ 1M w/1kHz) 60Hz - 20kHz +/- 3 dB 8/8 ohms per channel 7 SPEAKER SPECIFICATIONS Model: Description: Woofer: Tweeter: Cut-Out: Mounting Depth: Recommended Power: Efficiency: Frequency Response: Nominal Impedance: Model: Description: Woofer: Tweeter: Cut-Out: Mounting Depth: Recommended Power: Efficiency: Frequency Response: Nominal Impedance: Model: Description: Woofer: Tweeter: Cut-Out: Mounting Depth: Recommended Power: Efficiency: Frequency Response: Nominal Impedance: SP-C523 Round 2-Way In-wall/In-ceiling loudspeaker pair 5. 25" (13. 3 cm) poly-mica Pivoting 1/2" (1. 3 cm) Neodymium Mylar 6. 5" (16. 5 cm) 3. 25" (9. 5 cm) 5 - 60 watts 88 dB (1W @ 1M w/1kHz) 60Hz - 20kHz +/- 3 dB 8 ohms SP-C623 Round 2-Way In-wall/In-ceiling loudspeaker pair 6. 5" (16. 5 cm) poly-mica Pivoting 3/4" (1. 9 cm) Neodymium Mylar 7. 375" (18. 7) 3. 75" (9. 5 cm) 5 - 75 watts 89 dB (1W @ 1M w/1kHz) 55Hz - 20kHz +/- 3 dB 8 ohms SP-C550 Rectangular 2-Way In-wall/In-ceiling loudspeaker pair 5. 25" (13. 3 cm) poly-mica Pivoting 1/2" (1. 3 cm) Neodymium Mylar 9. 625" x 6. 125" (24. 5 cm x 15. 6 cm) 3. 25" (9. 5 cm) 5 - 60 watts 88 dB (1W @ 1M w/1kHz) 60Hz - 20kHz +/- 3 dB 8 ohms 8 SPEAKER SPECIFICATIONS Model: Description: Woofer: Tweeter: Cut-Out: Mounting Depth: Recommended Power: Efficiency: Frequency Response: Nominal Impedance: SP-C650 Rectangular 2-Way In-wall/In-ceiling loudspeaker pair 6. 5" (16. 5 cm) poly-mica Pivoting 3/4" (1. 9 cm) Neodymium Mylar 10. 75" x 7. 375" (27. 3 cm x 18. 7 cm) 3. 75" (9. 5 cm) 5 - 75 watts 89 dB (1W @ 1M w/1kHz) 55Hz - 20kHz +/- 3 dB 8 ohms WARRANTY All Russound Contractor Speaker products have a Five (5) year Limited Warranty against defects in materials and workmanship. Proof of Purchase must accompany all claims. [. . . ]