User manual RUSSOUND DIM-1

[. . . ] It also requires a 12VDC power supply (Russound 846C, not included). 1) Turn off the power to the doorbell transformer and the audio distribution system. You will be making open wire connections to the doorbell. [. . . ] The wire from the tip (+) connects to the "TRIG OUT (+)" (-) Sleeve terminal of the DIM-1. The other wire from the sleeve (-) connects to the "TRIG OUT (-)" of the DIM-1. Refer to Figure 2. POWER DOORBELL INTERFACE TRIG TRIG OUT +12V DC Figure 2 (+) Tip 4a) PR-4Zi Connection: For operation with the PR-4Zi, connect the 1/8" mini plug into the Mute Input connection. 4b) CAi Series Connection: For operation with the CA4. 4i/CA6. 4i, connect the 1/8" mini plug into the Mute Input connection. 4c) CAV Series Connection: For operation with the CAV6. 6, connect the 1/8" mini plug into the Page Trigger Input connection. Refer to Figure 5. POWER DOORBELL INTERFACE POWER DOORBELL INTERFACE POWER DOORBELL INTERFACE TRANS TRANS DB3 DB2 DB1 DB3 DB2 DB1 TRIG OUT TRIG OUT +12V DC TRIG TRIG TRIG TRIG OUT +12V DC +12V DC Figure 3 (-) Sleeve (+) Tip Figure 4 (-) Sleeve (+) Tip MUTE IN OUT Figure 5 (-) Sleeve (+) Tip PR-4Zi CAi Series CAV6. 6 TRANS DB3 DB2 DB1 TRANS DB3 DB2 DB1 Operating Instructions 1) Power the doorbell system and your audio distribution system. 2) Plug the 12VDC power supply into the DIM-1. After 6 seconds the green LED will go out. The green LED on the DIM-1 should illuminate for 6 seconds and then go out. 5) Ring the doorbell while the audio is playing. The audio should mute for 6 seconds and then return. Limited Warranty The Russound DIM-1 is fully guaranteed against all defects in materials and workmanship for two (2) years from the date of purchase. During this period, Russound will replace any defective parts and correct any defect in workmanship without charge for either parts or labor. For this warranty to apply, the unit must be installed and used according to its written instructions. If service is necessary, it must be performed by Russound. [. . . ] To return for repairs, the unit must be shipped to Russound at the owner's expense, along with a note explaining the nature of service required. Be sure to pack the unit in a corrugated container with at least three (3) inches of resilient material to protect the unit from damage in transit. Before returning a unit for repair, call Russound at (603) 659-5170 for a Return Authorization number. [. . . ]