User manual RUSSOUND DSC

[. . . ] 4) The DSC or DAN Keypad is now ready to be re-programmed (see Programming instructions). Reset Procedure Instructions: The Reset button is used to restart the DSC or DAN Keypad if any problem occurs during programming. If the DSC or DAN Keypad locks up for any reason, follow the procedure below. 1) Press the Reset button (shown in Figure 2). [. . . ] Be sure to pack in a corrugated container with at least 3 inches of resilient material to protect the unit from damage in transit. 5 Forbes Rd. Newmarket, NH 03857, USA 603. 659. 5170 · Fax 603. 659. 5388 e-mail: tech@russound. com Come visit us at: Conforms to UL 6500 Certified to CAN/CSA E65-94 Russound DSC & DAN Tested to Comply with FCC Standards FOR HOME OR OFFICE USE OPERATION INSTRUCTIONS 1) Read the Control Features section of the Multi-Zone Controller manual. 2) Select the source that you wish to control on the main keypad (this will also select the source for listening). 3) Press the command key(s) on the DSC or DAN which have been programmed with the commands that you wish to execute. 4) The Program indicator will flash as the command is outputted. If the Program indicator does not flash when the command key is pressed, the command was not stored properly. Direct Source Control Keypads DSC AND DAN Instruction Manual SEEK MODE SELECT 1 SCAN 4 5 6 2 3 7 8 9 DIRECT SOURCE CONTROL 0 ENTER DIRECT ACCESS NUMERIC SOURCE KEYPAD REV2 040502 PRODUCT OVERVIEW The DSC and DAN Keypads are state-of-the-art accessories to the Russound PR-4Z and CA-LCD multi-zone systems. The DSC (Direct Source Control) Keypad is programmable, allowing up to 12 stored functions for each of 6 pieces of source equipment. The DAN (Direct Access Numeric) source keypad allows specific numeric selections of the source equipment to be made, ideal for 100-disc players, satellite receivers, etc. The DSC and DAN Keypads connect to the main control keypads (PCK-IR, PCK, or CA-LCD Keypads) via a 16-pin header located on the side of the keypad. Infrared commands can be stored directly into the DSC and DAN Keypads using a simple programming procedure and the source equipment's remote. Commands are executed by simply pressing the keypad buttons to which the infrared commands were previously stored. Store and download DAN and DSC configurations. PROGRAMMING INSTRUCTIONS The command keys on the DSC or DAN Keypad are labeled for reference only. You may program any IR command onto any command key. 1) Read the Keypad Control Features section of the Multi-Zone Controller manual. 2) Turn on the zone using the main keypad. 3) Press the Program button on the left hand side of the DSC or DAN Keypad (Button locations are shown in Figure 2). 4) The Program Indicator will light continuously (indicator light locations are shown in Figure 2). 5) Select the layer by selecting the source input on the main keypad (i. e. , if you want to program CD player functions, select the CD source on the main keypad). [. . . ] All indicators will no longer be illuminated, and DSC Keypad will be ready for operation (see Operation instructions). 14) Program the DAN Keypad the same way the DSC Keypad was programmed. CONNECTION INSTRUCTIONS If the multi-zone system's main keypads (PCK-IR, PCK, or CA-LCD keypads) have not already been connected, refer to the instruction manual for that specific keypad. Once the main keypads have been wired, connect the DSC keypad's 16-pin header to the 16-pin receptacle on the side of the main keypad (see Figure 1a and 1b). Be sure to keep the correct pin alignment. [. . . ]