User manual RUSSOUND EZB-2SC

[. . . ] INSTRUCTIONS FOR CONNECTING RUSSOUND EZ-BLOCK The Russound EZ-BLOCK is fully guaranteed for ten (10) years from the date of purchase against all defects in materials and workmanship. For this warranty to apply, the unit must be installed and used according to its written instructions. During this period, Russound will replace any defective parts and correct any defect in workmanship with out charge for either parts or labor. [. . . ] Write the RA number on the shipping label and ship to: Russound, ATTN: Service, 5 Forbes Road, Newmarket NH 03857 Russound sells product only through authorized Dealers and Distributors to ensure that customers obtain proper support and service. Any Russound product purchased from an unauthorized dealer or other source, including retailers, mail order sellers and online sellers will not be honored or serviced under existing Russound warranty policy. Any sale of products by an unauthorized source or other manner not authorized by Russound shall void the warranty on the applicable product. LIMITED WARRANTY Models EZB-1SC, EZB-2SC EZ-BLOCK Modular Speaker Connecting Block 1 WIRING INSTRUCTIONS MOUNTING The EZ-BLOCKS are designed for surface mount applications. Position the EZ-BLOCK in an area close to the amplifier and volume control wiring. Secure to the mounting surface with four #8 x 1/2" screws. The EZ-BLOCK has removable modular connectors that provide color-coded wire termination without the need for set-screws. Strip about 3/8" of insulation from the ends of all wires to be connected. If necessary, twist the exposed conductor to insure that no loose strands exist. Remove the AMP INPUT connector by pulling up away from the board on the connector. Insert the wires from the amplifier speaker level output, being careful to observe proper polarity, and lower the lever with a "snap. " In the same way, connect each volume control to the appropriate SPEAKER connector. Each pair of speakers will then connect to the impedance-matching volume control. 3 Instruction Manual DESCRIPTION NOTE: This unit in and of itself provides no impedance matching. It is designed to be used in systems utilizing impedance -matching volume controls. 2 ADDING EZB-2SC SECTIONS An EZB-2SC allows for the connection of an additional 4 volume controls. To connect the EZB-2SC to the existing EZB-1SC, line up the male pin header on the end of the EZB-2SC with the female pin socket of the EZB-1SC. Make sure the two connectors line up properly; there should not be any pins extending beyond the end of the female connector. [. . . ] Accepts up to 14-gauge wire 1. 75"W x 0. 75"H x 4. 25"D (45x19x108mm) 1lb. (. 4g) CONNECTION DIAGRAMS FOR RUSSOUND EZ-BOCK. DIAGRAMS ARE NOT TO SCALE. EZB-1SC Amplifier Speaker wire EXPANSIONS Top view EZB-2SC RUSSOUND RUSSOUND SPEAKERS SPEAKERS SPEAKERS SPEAKERS RUSSOUND SPEAKERS EXPANSIONS SPEAKERS SPEAKERS SPEAKERS 1 IN Speaker wire 2 Side view Impedance-matching volume control (Russound ALTx-2sc) WHITE -- L+ (left channel positive) GREEN -- L- (left channel negative) BLACK -- R- (right channel negative) RED -- R+ (right channel positive) Speaker wire Speakers SPEAKERS SPEAKERS SPEAKERS SPEAKERS INPUT INPUT 3 SPEAKERS [. . . ]