User manual RUSSOUND KPSC

[. . . ] During this period, Russound will replace any defective parts and correct any defect in workmanship without charge for either parts or labor. For this warranty to apply, the unit must be installed and used according to its written instructions. If service is necessary, it must be performed by Russound. [. . . ] reserves the right to revise system specifications without notice. Note: The KPSC keypad cannot be used with a CAS44 controller system. KPSC Keypad Front Panel 1 2 3 4 Numeric entry function of button is located on inner edge Primary source control function of button is located on outer edge 1 PRIMARY CONTROLS - Functions on outer edge of buttons are default or normal operation for each selected source. These include play, stop, forward, back, pause, etc. FAVORITES - Set and recall two favorite settings of source and volume. NUMERIC VALUE SHIFT - Press to shift buttons to numeric control. Numeric Prefix "Disc" and Suffix "Enter" commands are sent upon entering and exiting Numeric control. NUMERIC ENTRY - Once numeric value control is initiated, the buttons now represent the numeric value when pressed (0-9). Press Numeric button to enter or exit Numeric Entry Mode NOTE: 1. Entering Numeric Entry Mode will send Prefix command 2. Exiting Numeric Entry Mode will send Suffix command All trademarks are property of their respective owners. 2 3 5 Forbes Road, Newmarket, NH 03857 tel 603. 659. 5170 · fax 603. 659. 5388 e-mail: tech@russound. com www. russound. com 28-1204 Rev. 1 11/02/05 4 KPSC Side Panel The KPSC 12-pin connector is located on the left side of the keypad (when facing front). This is covered when a trim plate is installed. Keypad Installation The KPSC connects to a KP6 or KPL keypad via a 12-pin connector. A double-gang electrical box and faceplate is required for installation. Check whether or not you can route the wire to the location you have chosen. To install a double-gang keypad, you will need to use a UL/CSA approved plastic two-gang (32 ci) electrical box. Route CAT-5 wire to the electrical box from the CAA66 system controller. Use a 110 punchdown tool to connect each wire to its corresponding color labeled on the KP6/KPL punchdown terminal. Refer to the KP6 or KPL keypad manual for complete instructions. Insert the KPSC 12-pin connector into the 12-pin header on the other keypad. Safety Instructions 1. Read Instructions - All the safety and operating instructions should be read before the appliance is operated. [. . . ] Mount the joined keypads in the electrical box and attach the trim plate. KPSC Front View 12. Damage Requiring Service - The appliance should be serviced by qualified service personnel when: A. Objects have fallen, liquid has been spilled into the appliance; or The appliance has been exposed to rain; or The appliance does not appear to operate normally; or The appliance has been dropped or the enclosure is damaged. 13. Servicing - The user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel. Precautions: 1. [. . . ]