User manual RUSSOUND SA-ZX3

[. . . ] During this period Russound will replace any defective parts and correct any defect in workmanship without charge for either parts or labor. For this warranty to apply, the unit must be installed and used according to its written instructions. If service is necessary, it must be performed by Russound. [. . . ] Any sale of products by an unauthorized source or other manner not authorized by Russound shall void the warranty on the applicable product. SA-ZX3 Keypad Splitter for Russound Controllers Connections The SA-ZX3 connects to the controller's keypad port with an RJ45 CAT-5 patch cable. The Keypad Ports are located on the back of the controller. Attach one end of an RJ45 CAT-5 patch cable to the controller's Keypad Port, and the other end to the SA-ZX3 Controller Keypad Port. Use an RJ45 CAT-5 patch cable between each SA-ZX3 Keypad Port and an RJ45 wall plate. Determine the length of CAT-5 needed to run between the wall plate and the room where the keypad is located. Terminate the CAT-5 as instructed at the wall plate using T568A standard. At the keypad end, terminate the CAT-5 using the 110 punchdown connection on the back of the keypad. Instruction Manual SA-ZX3 Overview The SA-ZX3 Keypad Splitter is an RNET® or CA controller system accessory that converts one Keypad Port on a controller into connections for up to three keypads. The SA-ZX3 can also be used to provide additional power when two or more UNO-TS2 Touchscreens are connected to a CAV6. 6 or CAM6. 6 controller. The SA-ZX3 requires a 1A 12VDC power supply (P/N 1201A). The SA-ZX3 connects to the controller's keypad port with an RJ45 CAT-5 patch cable. The keypad connects to the SA-ZX3 with a CAT-5 110 punchdown on the keypad end and an RJ45 connection on the SA-ZX3 end. All keypads sharing an SA-ZX3 control the same zone. If an UNO-TS2 Touchscreen shares an SA-ZX3 with an UNO-S1 or UNO-S2, the touchscreen must be configured for the same zone. Configuration All keypads sharing an SA-ZX3 control the same zone. If an UNO-TS2 Touchscreen shares an SA-ZX3 with an UNO-S1 or UNO-S2, the touchscreen must be configured for the same zone. See the UNO-TS2 Instruction Manual for details. Power Supply Each SA-ZX3 requires its own power supply. The 1201A power supply provides 12VDC 1A to power the SA-ZX3 and attached keypads. [. . . ] (0. 2 kg) Sample connection diagram for SA-ZX3 using CAV6. 6 controller and UNO keypads. Not drawn to scale. Do not connect the controller's main power feed until all other connections have been made and verified. Live connection or removal of the keypad wiring or other wiring when the system is powered can cause communication problems in the network. [. . . ]