User manual RUSSOUND SRC1

[. . . ] KEY FUNCTIONS Use the following Key Charts to learn how the SRC1 functions. Use Page Up/Down with cable or satellite boxes. Use these keys to select specific sources. SRC1 BASIC SYSTEM REMOTE CONTROL The LED (red light) blinks to show that the remote control is working and is sending signals. Press PWR once to turn on or off the zone. INSTALLING BATTERIES Use the keypad (0 ~ 9) to directly select channels (for example, 09 or 31). [. . . ] Press ENTER once after entering channel numbers on some TV models. Use VOL + (or VOL -) to raise (or lower) the sound volume. TROUBLESHOOTING Use CH + (or CH -) to select the next higher (or lower) channel. PROBLEM: LED does not blink when you press a key. SOLUTION: Replace the batteries with two (2) new AA alkaline batteries. PROBLEM: LED blinks when you press a key, but home entertainment component does not respond. SOLUTION: Make sure the SRC1 is aimed at your controller system keypad and is not farther than 15 feet away. PROBLEM: Changing channels does not work properly. SOLUTION: If original remote control required pressing ENTER to change channels, press ENTER on the SRC1 after entering the channel number. Press LAST once to recall the last channel and to page back one screen in the main menu. Press INPUT once to switch the input of the chosen component. Use EXIT to exit out of the selected component's menu or guide. Use F1/F2 to select and save favorite presets. ADDITIONAL INFORMATION The SRC1 does not have any user-serviceable parts. Opening the case, except for the battery cover, may cause permanent damage to the SRC1. Russound 5 Forbes Road Newmarket NH 03857 603. 659. 5170 www. russound. com 28-1205 07/08/05 Use the cursor keys to move the cursor in the program guide and menu screens. [. . . ] The SRC1 is a system remote only and does not support learning IR codes. This manual provides a basic overview on how to operate the SRC1. [. . . ]