User manual RUSSOUND UNO-LRC1

[. . . ] UNO-LRC1 UNIVERSAL LEARNING & PREPROGRAMMED REMOTE CONTROL Press VID, DVD, TV, or UNO once to select a home entertainmentcomponent to control. Use the keypad (0 ~ 9) to directly select channels (for example, 09 or 31). Press MUTE once to turn sound off or on. Press ENTER once after entering channel numbers on some TV models. [. . . ] Then press and release the device key to be cleared twice. PROBLEM: Remote control does not turn on Sony or Sharp TV/VCR Combo. SOLUTION: For power on, these prod-ucts require programming TV codes. For Sony, use TV code 0000 and VCR code 0032. For Sharp, use TV code 0093 and VCR code 0048. PROGRAMMING COMPONENT CONTROL The UNO-LRC1 can control up to eight different components. Perform the following instructions for each component you want controlled: NOTE: For TV/VCR Combo control, see the next section. LEARNING CAPABILITY To optimize success, the learning process should be conducted in an area where there is a low level of IR emission. High levels of "natural light" or energy efficient fluorescent lights could interfere with a learning event The source and target (learner) remotes should be no more than 1 to 2 inches apart during a learning event and the IR LEDs of the two units should be aligned with each other. The learning operation is initiated as follows: 1. Press and hold SETUP until double blink confirmation. Press 9 - 7 - 5 to initiate learning mode. Press [MODE] and key to be learned (time out if no key pressed in 10 seconds). Visible LED flashes rapidly (time out if no received signal detected in 4 sec. ) 4. Hold teaching remote close to IR LED and press key to be taught. Continue to press teaching key until double blink from visible LED. (One long blink indicates a learning failure) 6. Repeat steps 2 through 5 as often as desired (up to limit of memory). Exit learning mode by pressing SETUP, or by time out (10 seconds). At step 5, one long blink indicates learning failure, which could be: · There are certain device codes which are not learnable. These include multi-frequency codes (e. g. Telefunken), some high frequency codes, and other unusual formats. · The learner will support IR codes with carrier frequency up to 135 Khz. · The unit can learn only one code per key. It can't be taught a sequence of several keystrokes on one key. [. . . ] If it does not respond, repeat steps 2-3, trying each code for your brand until you find one that works. If it still does not work, try searching for the code (see Searching For Your Code). NOTE: If the device does not have a PWR key, press PLAY. To change Volume Lock to another mode: 1. On the UNO-LRC1, press and hold SETUP until the LED blinks twice, then release SETUP. Enter 9 - 9 - 3 and then press any mode key once (except TV). [. . . ]