User manual RYOBI 0131030330

[. . . ] Before beginning operation, always wear safety goggles or safety glasses with side shields and a full face shield when needed. We recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses with side shields. [. . . ] Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the tool better and safer. SYMBOL NAME DESIGNATION/EXPLANATION V A Hz W min Volts Amperes Hertz Watt Minutes Alternating Current --- Voltage Current Frequency (cycles per second) Power Time Type of current Type or a characteristic of current Rotational speed, at no load Double-insulated construction Revolutions, strokes, surface speed, orbits etc. , per minute Precautions that involve your safety The manual contains special messages to bring attention to potential safety concerns and machine damage as well as helpful operating and servicing information. Please read all the information carefully to avoid injury and machine damage. Always wear safety goggles or safety glasses with side shields and a full face shield when operating this product. Direct Current No Load Speed Class II Construction n0 . . . /min Per Minute Safety Alert Read The Operator's Manual Eye Protection Wet Conditions Alert Do not expose to rain or use in damp locations. SAVE THESE INSTRUCTIONS 3 UNPACKING INFORMATION Remove the loose parts from the box. Inspect the dado throat plate carefully to make sure no breakage or damage occurred during shipping. If the dado throat plate is damaged, please call 1-800-525-2579 for assistance. LOOSE PARTS LIST Dado throat plate 10-24 x 1/2 in. flat head screw (1) TOOLS NEEDED Phillips head screwdriver WARNING: If any parts are missing, replace the missing parts before assembling the kit. Failure to do so could result in serious personal injury. 10-24 X 1/2 IN. SCREW THROAT PLATE 4 INSTALLATION INSTALLING A DADO INSERT WARNING: Failure to turn the saw off, remove the switch key, and unplug the saw could result in accidental starting causing possible serious personal injury. Lower the blade below the table surface. Loosen the screw and remove the throat plate. Remove the blade and blade guard assembly following instructions in the table saw Operator's Manual. Included with the dado blade are installation instructions. [. . . ] Remove the dado insert and dado set or molding head. Reinstall the blade, blade guard assembly, and throat plate following instructions in the Operator's Manual. WARNING: To reduce the risk of injury and before plugging the saw back in, make sure the blade guard is installed and working properly. [. . . ]