User manual RYOBI 132R

[. . . ] 105r, 132r, & 137r Electric Trimmers OPERATOR'S MANUAL FOR QUESTIONS, CALL 1-800-345-8746 in U. S. or 1-800-265-6778 in CANADA www. ryobi. com IMPORTANT MANUAL DO NOT THROW AWAY INTRODUCTION THANK YOU Thank you for purchasing this quality product. This modern outdoor power tool is designed to provide many hours of useful service. You will find it to be a great labor-saving device. [. . . ] OTHER SAFETY WARNINGS · Disconnect the unit from the power supply when not in use, before servicing, when changing accessories such as cutting head, and the like. Do not touch blade. · SPEED SWITCH OR THROTTLE SWITCH Indicates "HIGH" or "FASTEST" speed. · SPEED SWITCH OR THROTTLE SWITCH Indicates "LOW" or "SLOWEST" speed. 6 ASSEMBLY INSTRUCTIONS If the D-Handle on your unit is not assembled, use the following instructions. Push the D-Handle down over the boom (Fig. Install the bolt, washer, and wing nut, and tighten (Fig. If the string guard on your unit is not installed, use the following instructions. INSTALLING THE STRING GUARD MODELS 105r AND 132r WARNING: To avoid serious personal injury, never operate the trimmer without the string guard in place. Place the string guard onto the boom above the clamp assembly (Fig. 1 If the D-Handle on your unit is assembled, use the following instructions. It is not necessary to remove the wing nut, washer and bolt. Rotate the D-Handle 180º (top of the boom) to the correct operating position. Position the D-Handle as desired and tighten the wing nut (Fig. Push the string guard down to the top of the string head assembly and then rotate the string guard to the proper position (Fig. Install the screws with a Phillips screwdriver (Fig. 5 7 ASSEMBLY INSTRUCTIONS If the string guard on your unit is not installed, use the following instructions. INSTALLING THE STRING GUARD MODEL 137r WARNING: To avoid serious personal injury, never operate the trimmer without the string guard in place. Slide the string guard onto the guard mount above the string head assembly. Align the screw holes in the string guard with the screw holes in the string assembly (Fig. Install the screws into the holes from the bottom of the guard (Fig. Place the three hex nuts into the recessed holes on top of the guard (Fig. 8 OPERATING INSTRUCTIONS This trimmer has been designed and built to withstand normal use. It will provide many hours of service provided the operating instructions are closely followed. WARNING: Always wear eye, hearing, foot and body protection to reduce the risk of injury when operating this unit. [. . . ] This warranty extends to the original retail purchaser only and commences on the date of original retail purchase. Any part of the RYOBI Product manufactured or supplied by RYOBI and found in the reasonable judgement of RYOBI to be defective in material or workmanship will be repaired or replaced by an authorized RYOBI service dealer without charge for parts and labor. The RYOBI Product including any defective part must be returned to an authorized service dealer within the warranty period. The expense of delivering the RYOBI Product to the dealer for warranty work and the expense of returning it back to the owner after repair or replacement will be paid for by the owner. [. . . ]