User manual RYOBI 14.4V COMPACT IMPACT DRILL LCDI14022

[. . . ] LCDI1402 14. 4 VOLT COMPACT HAMMER DRILL DRIVER OWNER'S OPERATING MANUAL DESCRIPTION 1. Keyless chuck Torque adjustment ring Quick mode selector Two-speed gear train Rotation selector (forward/reverse/center lock) Bit storage Trigger switch Mag TrayTM Battery pack Latches Depress latches to release battery pack Reverse Forward Chuck jaws 15. Lock (tighten) Unlock (release) Low speed High speed Drive mode Drill mode Hammer mode To increase torque To decrease torque Bit Screws Bit holder Drill bit Chuck sleeve 3 2 4 26 24 25 8 5 1 7 10 9 9 6 11 Fig. 2 7 8 19 20 21 12 13 3 5 7 Fig. [. . . ] If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from the battery may cause irritation or burns. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and 2 SPECIfICATIONS Voltage Chuck Switch No load speed (Drill mode): -Lo speed -Hi speed Hammer speed (Blows per minute): -Lo speed -Hi speed Max. battery pack) 14. 4 V 2-13 mm Variable speed 0-440 min-1 0-1600 min-1 0-5720 min-1 0-20800 min-1 37. 5 Nm 1. 43 Kg English SPECIfICATIONS MODEL BATTERy PACK (not included) 130224024 130111073 BPP-1413 BPP-1415 BPP-1417 COMPATIBLE CHARGER (not included) 140262011 140289013 140217023 140268007 140427003 140111074 140268008 BCL1418 BCL1418 This product will accept RYOBI 14. 4 V lithium-ion battery packs and RYOBI 14. 4 V nickel-cadmium battery packs. BATTERy PROTECTION fEATURES RYOBI 14. 4 V lithium-ion batteries are designed with features that protect the lithium-ion cells and maximise battery life. Under some operating conditions, these built-in features may cause the battery and the tool it is powering to act differently from nickel-cadmium batteries. During some applications, the battery electronics may signal the battery to shut down, and cause the tool to stop running. To reset the battery and tool, release the trigger and resume normal operation. NOTE: To prevent further shut down of the battery, avoid forcing the tool. If releasing the trigger does not reset the battery and tool, the battery pack is depleted. If depleted, the battery pack will begin charging when placed on the lithium-ion charger. Lock the trigger switch by placing the rotation selector in the center position. Make sure the latches on each side of the battery pack snap into place and the battery pack is secured on the tool before beginning operation. WARNING Always remove battery pack from your tool when you are assembling parts, making adjustments, cleaning, or when not in use. Removing battery pack will prevent accidental starting that could cause serious personal injury. Lock the trigger switch by placing the rotation selector in the center position. Depress the latches on the side of battery pack. WARNING Battery tools are always in operating condition. Therefore, the switch should always be locked when not in use or carrying at your side. LCDI1402 BPL1414 OPERATION WARNING Do not allow familiarity with products to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING Always wear safety goggles or safety glasses with side shields when operating products. [. . . ] Depress the trigger switch to start the drill. Move the drill bit into the workpiece, applying only enough pressure to keep the bit cutting. Do not force the drill or apply side pressure to elongate a hole. WARNING: Be prepared for binding at bit breakthrough. [. . . ]