User manual RYOBI 14.4V IMPACT DRILL DRIVER KIT CID1442P

[. . . ] OPERATOR'S MANUAL CORDLESS IMPACT DRILL-DRIVER MODEL NO. CID1442P/CID1802P THANK YOU FOR BUYING A RYOBI CORDLESS IMPACT DRILL-DRIVER. Your new cordless impact drill-driver has been engineered and manufactured to Ryobi's high standard for dependability, ease of operation, and operator safety. Properly cared for, it will give you years of rugged, trouble-free performance. [. . . ] When battery pack has been charged, disconnect charging assembly from power supply and remove the battery pack. This practice will increase battery life. I I I I I TWO SPEED GEAR TRAIN See Figure 1B. Your drill has a two-speed gear train designed for drilling or driving at LO (1) or HI (2) speeds. A slide switch is located on top of your drill to select either LO (1) or HI (2) speed. When using drill in the LO (1) speed range, speed will decrease and unit will have more power and torque. When using drill in the HI (2) speed range, speed will increase and unit will have less power and torque. Use LO (1) speed for high power and torque applications and HI (2) speed for fast drilling or driving applications. Page 7 OPERATION MODEL CID1802P LED FUNCTION OF CHARGER 2601038 See Figure 2. . LED WILL BE LIGHTED TO INDICATE STATUS OF CHARGER AND BATTERY PACK: Red LED lighted = Fast Charging Mode Green LED lighted = Fully Charged Battery Pack Yellow and Green LED Lighted = Control Charge or Defective Battery Pack. CHARGING BATTERY PACK The battery pack for this tool has been shipped in a low charge condition to prevent possible problems. Therefore, you should charge it prior to use. NOTE: Batteries will not reach full charge the first time they are charged. Allow several cycles (cutting followed by recharging) for them to fully charge. Charge battery pack only with the charger provided. Make sure power supply is normal house voltage, 240 Volts, 50 Hz, AC only. Place battery pack in charger. See Figure A. Align raised rib on battery pack with groove in charger. Press down on battery pack to be sure contacts on battery pack engage properly with contacts in charger. When properly connected, red light will turn on. Normally, the yellow and green lights on the charger will come on. This indicates charger is in control charge mode and should switch to fast charge mode within 5 minutes. When charger is in fast charge mode the red light will come on. If after a period of 15 minutes the yellow and green lights remain on, remove the battery pack, wait 1 minute and reinsert battery pack in charger. If the yellow and green lights continue to remain on an additional 15 minutes, the battery pack is damaged and will not accept charge. When your battery pack becomes fully charged, the red light will turn off and the green light will turn on. [. . . ] To obtain the longest possible battery life, we suggest the following: I Store and charge your batteries in a cool area. Temperatures above normal room temperature wil shorten battery life. Never store batteries in a discharged condition. Wait for battery to cool and charge immediately. [. . . ]