User manual RYOBI 14.4V IMPACT DRILL DRIVER KIT WITH AUX HANDLE CBI1442D

[. . . ] OPERATOR'S MANUAL CORDLESS IMPACT DRILL-DRIVER MODEL NO. CBI1442D / CBI1802D This new cordless Impact drill-driver has been engineered and manufactured to Ryobi's high standard for dependability, ease of operation, and operator safety. When properly cared for, the drill-driver will give you years of rugged, trouble-free performance. WARNING: To reduce the risk of injury, the user must read and understand the operator's manual before using this product. Thank you for buying a Ryobi product. SAVE THIS MANUAL FOR FUTURE REFERENCE 1. [. . . ] There are no user serviceable parts in your power tool. Never use water or chemical cleaners to clean your power tool. Always store your power tool in a dry place. If you see some sparks flashing in the ventilation slots, this is normal and will not damage your power tool. WORKING HINTS FOR YOUR DRILL If your power tool becomes too hot, set the speed to maximum and run no load for 2-3 minutes to cool the motor. Always use a magnetic bit holder when using short screwdriver bits. Where possible use a pilot hole before drilling a large diameter hole. OPERATION CONTENTS OF BOX 14. 4V/18. 0V cordless hammer drill, 2 double-ended bits, 2 battery packs, charger, auxiliary handle. OPERATING INSTRUCTIONS CHARGING THE BATTERY PACK (fig. 1) The battery packs for this tool have been shipped in a low charge condition to prevent possible problems. You should, therefore, charge them prior to use. Note: Batteries will not reach full charge the first time they are charged. Allow several cycles (drilling followed by recharging) for the item to fully charge. The battery charger should only be used indoors. Make sure power supply is normal house voltage, 240VoHs, 50Hg, AC only. Place the battery pack into the charger as indicated. Align raised rib on battery pack with groove in charger. Press down on battery pack to make sure contacts on battery pack engage properly with contacts in charger. When properly connected, the red light on charger will turn on. After normal usage, 1 hour of charging time is required for the battery to be fully charged. Note: Normally the red light on the charger will come on, this indicates charge mode. If the green and yellow lights come on, remove the battery pack, wait 1 minute and reinsert battery pack in charger. If the green and yellow lights continue to remain on an additional 15 minutes, the battery pack is damaged and will not accept charge. [. . . ] Failure to comply with these warnings could result in fire and/or serious injury. Page 4 SPECIFICATIONS Drill voltage Switch Chuck No load speed: Drill mode Impact mode Power supply Torque No. of Power Pack Weight Charger input Charging time Battery pack Charger 14. 4V variable, forward & reverse 13mm keyless (steel max. Ø10mm) 0-350 / 0-1300 /min 0-4550 / 0-16900 bpm 12 x 1. 2V Ni-Cd 1500mAh 32Nm 2pcs 2. 1 kg (with battery) AC 240V 50Hz 1 hour (approx. ) 130262022 2601050 18. 0 V variable, forward & reverse 13mm keyless (steel max. Ø10mm) 0-400 / 0-1400 /min 0-5200 / 0-18200 bpm 15 x 1. 2V Ni-Cd 1500mAh 35Nm 2pcs 2. 4 kg (with battery) AC 240V 50Hz 1 hour (approx. ) 130262021 2601038 MAINTENANCE WARNING: When servicing, use only identical replacement parts. [. . . ]