User manual RYOBI 147300

[. . . ] Stop machine is anyone enters the area. Before operation WARNING: The appliance must be assembled correctly before use. The appliance should be checked carefully before use. You should only work with an appliance that is in good condition. If you notice any defect on the machine that may cause danger to the operator, do not operate the appliance until defects are rectified. [. . . ] The power supply cable should be checked regularly and before using it each time, make sure the cable is not damaged or old out. If the cable is not in good condition, do not use the appliance; take it to an authorized service center instead. Only use an extension cable that is suitable for outdoor work. Keep it away from the cutting area, from damp, wet or oily surfaces or with sharp edges and away from heat and fuels. Use only connection or extension cord with a maximum length of 15m and a minimum cable diameter of 0. 75 mm ². If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent. FEATURES Rated power Rated voltage No load speed Vibration Sound pressure level Guaranteed sound power level Weight (without cord) Protection degree See Figure 2 PRODUCT SPECIFICATIONS 1020 W 220-240V ~ 50Hz 340 /min 2. 3m/s2, k=1. 5 m/s2 LpA:80dB(A) KpA:2dB(A) 93dB(A) 13. 8 kg IPX4 KNOW YOUR CULTIVATOR The safe use of this product requires an understanding of the information on the tool and in this operator's manual as well as a knowledge of the project you are attempting. Before use of this product, familiarize yourself with all operating features and safety rules. SWITCH LOCK-OUT SWITCH TRIGGER The switch lock-out prevents accidental starting of the cultivator. The switch trigger starts and stops the rotation of the tines. DESCRIPTION See Fig. 1 to Fig. 13 for these parts. Shallow position EXTENSION CORDS When using a cultivator at a considerable distance from the power source, use an extension cord heavy enough to carry the current that the tool will draw. An undersized extension cord will cause a drop in line voltage, resulting in a loss of power and causing the motor to overheat. Place a washer on the outside of the wheel and slide to rest against the wheel. Lean the unit back on its wheels so that the handlebar rests on the ground. WARNING: 7 English (Original Instructions) OPERATION Place tine C on the tine shaft to the left of the gear box. The stamped side of the tine should face away from the gear box. Place tine B on the tine shaft to the right of the gear box. The stamped side of the tine should face away from the gear box. Place a felt washer on each side of the tine shaft, and slide to rest against the inner tines. Place the outer tine stamped D on the left side of the tine shaft. The stamped side should face in toward tine C. Place the outer tine stamped A on the right side of the tine shaft. The stamped side should face in toward tine B. The cultivator can be used to break up garden soil and prepare a seedbed for planting. Plan ahead to leave enough room between the seed rows to allow for machine cultivating after the plants have grown. [. . . ] Unfold the handles into the upright position and secure by tightening handlebar knobs. Do not allow the switch trigger cable to become pinched when raising the handlebar. Follow the steps to restart the cultivator. WARNING: Do not at any time let brake fluids, gasoline, petroleumbased products, penetrating oils, etc. , come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury. Only the parts shown on the parts list are intended to be repaired or replaced by the customer. [. . . ]