User manual RYOBI LCD 1802

[. . . ] LCD1802 COMPACT DRILL DRIVER OWNER'S OPERATING MANUAL DESCRIPTION 1. Keyless Chuck Switch Trigger Direction of Rotation Selector (Forward/reverse) Double-Ended Bits Magnetic Tray Battery Pack (not included) Latches Depress Latched To Release Battery Pack 9. Torque Adjusting Ring To Decrease Torque To Increase Torque Reverse Forward Unlock (Release) Lock (Tighten) Chuck Jaws 17. High Speed Low Speed Two-Speed Gear Train Bit Storage Drill Bit Bubble Leves 22 9 1 6 19 3 2 5 8 7 8 4 3 12 Fig. [. . . ] SERVICE Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. OPERATION WARNING Do not allow familiarity with products to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING Always wear safety goggles or safety glasses with side shields when operating products. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury. WARNING Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. APPLICATIONS You may use this product for the purposes listed below: Drilling in all types of wood products (lumber, plywood, paneling, composition board, and hard board) 2 This appliance is not intended for use by young children or infirm persons unless they have been adequately supervised by a responsible person to ensure that they do not play with the appliance. Visitors should wear safety glasses and be kept a safe distance from work area. Do not let visitors contact tool or extension cord. English OPERATION Drilling in ceramics, plastics, fiberglass, and laminates Drilling in metals Mixing paint WARNING Battery products are always in operating condition. Therefore, the switch should always be locked when not in use or carrying at your side. This product will accept Ryobi One+ 18 V lithium-ion battery packs and Ryobi One+ 18 V nickel-cadmium battery packs. WARNING Always remove battery pack from your drill when you are assembling parts, making adjustments, assembling or removing bits, cleaning, or when not in use. Removing battery pack will prevent accidental starting that could cause serious personal injury. SWITCH TRIGGER See Figure 3. To turn the drill ON, depress the switch trigger. To turn it OFF, release the switch trigger. VARIABLE SPEED The variable speed switch trigger delivers higher speed with increased trigger pressure and lower speed with decreased trigger pressure. NOTE: You might hear a whistling or ringing noise from the switch during use. Do not be concerned; this is a normal part of the switch function. DIRECTION OF ROTATION SELECTOR (FORWARD/REVERSE/CENTER LOCK) BATTERY PROTECTION FEATURES Ryobi 18 V lithium-ion batteries are designed with features that protect the lithium-ion cells and maximize battery life. Under some operating conditions, these built-in features may cause the battery and the tool it is powering to act differently from nickel-cadmium batteries. [. . . ] Remove the bit from the workpiece and determine the reason for jamming. When the switch trigger is released, the chuck stops turning. When the brake is functioning properly, sparks will be visible through the vent slots on the housing. This is normal and is the action of the brake. [. . . ]