User manual RYOBI 18V ONE PLANER CPL1800G

[. . . ] OPERATOR'S MANUAL 18 VOLT HAND PLANER CPL1800 BATTERIES AND CHARGERS SOLD SEPARATELY Your planer has been engineered and manufactured to our high standard for dependability, ease of operation and operator safety. When properly cared for, it will give you years of rugged, trouble-free performance. this product. WARNING: To reduce the risk of injury, the user must read and understand the operator's manual before using Thank you for buying a Ryobi product. SAVE THIS MANUAL FOR FUTURE REFERENCE TABLE OF CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 General Safety Rules . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-4 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] To install, slide the dust bag adaptor onto the chip dust port on the planer. To remove the dust bag, grasp the adaptor and pull the dust bag away from the planer. 3 OPERATION WARNING: Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. NOTE: Batteries will not reach full charge the first time they are charged. Allow several cycles (operation followed by recharging) for them to become fully charged. CHARGING A COOL BATTERY PACK If battery pack is within normal temperature range, the red LED on charger will come on. NOTE: If the charger does not charge the battery pack under normal circumstances, return both the battery pack and charger to your nearest Authorised Service Centre for electrical check. Charge the battery pack only with the charger provided. Make sure the power supply is normal household voltage, 240 volts, 50 Hz, AC only. Connect the charger to the power supply. Place the battery pack in the charger aligning raised rib on the battery pack with the groove in the charger. Press down on the battery pack to be sure contacts on the battery pack engage properly with contacts in the charger. Normally the red LED on charger will come on. This indicates the charger is in fast charging mode. Red LED should remain on for approximately 1 hour then the green LED will come on. Green LED on indicates battery pack is fully charged and charger is in maintenance charge mode. NOTE: The green LED will remain on until the battery pack is removed from the charger or charger is disconnected from the power supply. If both yellow and green LEDs come on, this indicates a deeply discharged or defective battery pack. Allow the battery pack to remain in the charger for 15 to 30 minutes. When the battery pack reaches normal voltage range, the red LED should come on. If the red LED does not come on after 30 minutes, this may indicate a defective battery pack that should be replaced. After normal usage, a minimum of 1 hour of charging time is required to fully recharge battery pack. [. . . ] Make sure the belt is flush with the edge of both pulleys. Install the belt cover screws and tighten securely. 18 18 MAINTENANCE CLEANING THE CHIP DUST PORT AND EMPTYING THE DUST BAG See Figure 19. After using the planer for an extended period of time or when planing wet or green timber, chips may build up in the chip dust port. [. . . ]