User manual RYOBI 20006

[. . . ] 6 90° 90° 2 2 12 12 Fig. 8 Important! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications. English GENERAL POWER TOOL SAFETY WARNINGS 3. Stay alert, watch what you are doing and use common sense when operating a power tool. [. . . ] This will ensure that the safety of the power tool is maintained. instructions listed below may result in electric shock, fire and/or serious injury. Operations for which the power tool was not designed may create a hazard and cause personal injury. Do not use accessories which are not specifically designed and recommended by the tool manufacturer. Just because the accessory can be attached to your power tool, it does not assure safe operation. The rated speed of the accessory must be at least equal to the maximum speed marked on the power tool. Accessories running faster than their rated speed can break and fly apart. The outside diameter and the thickness of your accessory must be within the capacity rating of your power tool. Incorrectly sized accessories cannot be adequately guarded or controlled. The arbour size of wheels, flanges, backing pads or any other accessory must properly fit the spindle of the power tool. Accessories with arbour holes that do not match the mounting hardware of the power tool will run out of balance, vibrate excessively and may cause loss of control. Position the cord clear of the spinning accessory. If you lose control, the cord may be cut or snagged and your hand or arm may be pulled into the spinning accessory. Never lay the power tool down until the accessory has come to a complete stop. The spinning accessory may grab the surface and pull the power tool out of your control. Do not run the power tool while carrying it at your side. Accidental contact with the spinning accessory could snag your clothing, pulling the accessory into your body. Regularly clean the power tool's air vents. The motor's fan will draw the dust inside the housing and excessive accumulation of powdered metal may cause electrical hazards. Do not operate the power tool near flammable materials. Do not use accessories that require liquid coolants. Using water or other liquid coolants may result in electrocution or shock. [. . . ] Wheel intended for larger power tool is not suitable for the higher speed of a smaller tool and may burst. English ANGLE GRINDER SAFETY PRECAUTIONS Check that the speed marked on the grinding wheel is equal to or greater than the rated speed of the tool. Ensure that the dimensions of the grinding wheel are compatible with the tool and that the wheel fits the spindle. Grinding wheels must be stored in a dry place. Do not store objects on top of the grinding wheels. [. . . ]