User manual RYOBI 20007

[. . . ] (Fig. 14a) Note: Make sure that the square contacts the flat part of the saw blade, not the blade teeth. The edge of the square and the saw blade should be parallel as shown in Fig. If the front or back edge of the saw blade angles(a) away from the square as shown in Fig. Loosen the socket head screws(b) that secure the rear fence(13) to the mitre table(11). [. . . ] As mentioned previously your saw has been factory assembled and adjusted. The dust bag, vice and material supports are the only parts that have to be installed. 10, 11&12) DANGER: A 254mm x 2. 0mm diameter blade is the maximum blade capacity of your saw. Never use a blade that is too thick to allow outer blade washer to engage with the flats on the spindle. Larger blades will come in contact with the blade guards, while thicker blades will prevent the blade screw from securing the blade on the spindle. Either of these situations will result in a serious accident and can cause serious personal injury. Remove the screw(a) on the link(c) and loosen the philips screw on the blade bolt cover until the lower blade guard(4) assembly can be raised to expose the blade bolt. 10) Depress the spindle lock button(15) while rotating the blade. 11) Loosen screw(a) and outer blade flange(b) to replace the blade(c). Please Note - This is a left hand thread, so loosen in a CLOCKWISE direction(Fig. Remove the outer blade washer and the blade. 26b) Fasten the set screw so that the new turning angle of the handle to lock the table is redefined. 26c) OPERATION APPLICATIONS (Use only for the purposes listed below) Cross Cutting wood. Cross Cutting mitres, joints etc. , for picture frames, moldings, door casings and fine joinery. NOTE: The crosscut blade provided is for most wood cutting operations. CUTTING WITH YOUR COMPOUND MITRE SAW WARNING: Before starting any cutting operations, clamp or bolt your compound mitre saw to a workbench. Never operate your mitre saw on the floor of in a crouched postion. Failure to heed this warning can result in serious personal injury. Page 14 WARNING: Use the vice to secure your workpiece on one side of the blade only. The workpiece must remain free on one side of the blade to prevent the blade from binding in workpiece. The workpiece binding blade will cause motor stalling and kickback. This situation could cause an accident resulting in serious personal injury. 27) When the machine is connected with the power supply, the live indicator(24) always glow. [. . . ] This product is sold by the dealer or agent as principal and the dealer has no authority from the Company to give any additional guarantee on the Company's behalf except as herein contained or herein referred to. Guarantee Conditions This guarantee only applies provided that the Product has been used in accordance with the manufacturer's recommendations under normal use and reasonable care (in the opinion of the Company) and such guarantee does not cover damage, malfunction or failure resulting from misuse, neglect, abuse, or used for a purpose for which it was not designed or is not suited and no repairs, alterations or modifications have been attempted by other than an Authorised Service Agent. This guarantee will not apply if the tool is damaged by accident or if repairs arise from normal wear and tear. The Company accepts no additional liability pursuant to this guarantee for the costs of travelling or transportation of the Product or parts to and from the service dealer or agent - such costs are not included in this guarantee. [. . . ]