User manual RYOBI 280W 1/3 SHEET SANDER ESS280RG

[. . . ] ESS200RG / ESS280RG 1/3 SHEET SANDER OWNER'S OPERATING MANUAL ESS200RG ESS280RG DESCRIPTION 1. On/off trigger switch Variable speed control selector Overmold handle Dust collection box Sanding pad 6. Paper punch ESS200RG 1 3 7 ESS280RG 2 1 7 3 4 4 6 5 6 5 Fig. 8 Important! It is essential that you read the instructions in this manual before operating this machine. [. . . ] Adequate supervision by a responsible person must be provided to ensure that they do not play with the appliance. Visitors should wear safety glasses and be kept a safe distance from work area. Do not let visitors contact tool or extension cord. Recommended for the use of a residual current device with a rated residual current of 30 mA or less. FEATURES See Figure 1. Your sander is suitable for sanding with coarse, medium and fine grit sandpaper. It will produce a fine scratch free finish when used to sand with the grain on wood surfaces. It has been designed so that flush corner sanding on three sides of the sander is possible. Your sander has a comfortable palm grip handle that provides maximum one-hand comfort and reduces operator fatigue during continuous sanding operations. Before using this product, familiarize yourself with all operating features and safety requirements. However, do not let familiarity with the tool make you careless. SWITCH Electronic speed control (ESS280RG only) The electronic speed control allows the operator to adjust speed to meet a variety of sanding material from tough heavy grained timber to delicate veneer. Both ESS200RG and ESS280RG are equipped with a 2 SPECIFIC SAFETY INSTRUCTIONS FOR SANDERS Always wear safety goggles and a dust mask when sanding, especially sanding over-head. The machine is not suitable for wet sanding. Do not use sanding paper larger than needed. Extra paper extending beyond the sanding pad can also cause serious lacerations. English simple switch control. To turn the sander "On", slide the switch to " I ". To turn the sander " Off ", slide the switch to "O". and finer grit will produce the best finish in all sanding operations. The condition of the surface to be sanded will determine which grit will do the job. If the surface is rough, start with a coarse grit and sand until the surface is uniform. Medium grit may then be used to remove scratches left by the coarser grit and finer grit used for finishing of the surface. Always continue sanding with each grit until surface is uniform. WARNING Do not allow familiarity with your sander to make you careless. [. . . ] Unplug the sander. WARNING When servicing, use only identical Ryobi replacement parts. Use of any other parts may create a hazard or cause product damage. GENERAL WARNING Failure to unplug the tool could result in accidental starting causing possible serious injury. Remove the dust collection box from the sander. Reattach the dust collection box to the sander. [. . . ]